Leckey Freestander User Manual - page 5
Check parts
Congratulations on purchasing your Leckey
Freestander. When you receive your
Freestander it will be boxed and wrapped in
several parcels. Your Freestander comes as
standard with chest plate including flexible
laterals, knee plate, pelvic strap, activity tray
and bowl, base with castors, inner poles
and sandals.
The Totstander is supplied without castors,
tray and with a chest strap instead of a solid
chest plate. Carefully remove all the parcels
from the box and check you have all the
parts you have ordered.
Safety first
Keep polythene bags away from
children.
To assemble your Freestander, firstly loosen
the height adjustment bolt’s (a) on the outer
upright poles and remove the inner poles.
Insert the inner poles into place into the
receiver tubes on the base castor frame.
The allen key provided tighten the two small
socket screws on each receiver
tube securely (b).
Then slide the main outer frame over
the inner poles and tighten the two
height adjustment bolts (c) at the
desired height.
7.1 Assembling the
Freestander
b
a
c
c
The Freestander tray is attached by sliding
the outer poles already attached to the tray
over the inner poles already attached to the
base and then tightening the bolts (a).
The tray is then secured with a tray pin into
one of the slots on the side of the frame.
7.2 Attaching the Tray
7.3 Attaching the
sandals
a
A
1
2
3
B
D
C
C
D
Insert the required attachment bolt (a) along
with the retention plate (b). Place a rubber lid
(c) on both the top and bottom of the sandal.
Fasten using the four screws (d) provided.
To remove or replace the attachment bolt,
reverse this process.