Leckey Squiggles User Instructions - page 6
To attach the footrest to the seat base,
remove the bolt and nut from the metal
stem on the footrest. Then slide the metal
tube into the moulding as shown. When the
hole in the metal plate is aligned with the
hole in the moulding, replace the bolt and
secure with the nut provided. Make sure
the end of the bolt protrudes from the end
of the nut.
You can now attach the seat to your
chassis and complete the assembly of the
product and any accessories you have
ordered.
Always make sure the foot plate is
attached firmly.
7.3 Attaching the
footrest
Adjust the height of the chassis to its
maximum to reduce risk of back strain
while attaching the seat unit. Refer to
Section 11 on how to adjust the height of
the chassis you have purchased.
First release the safety locking pin (A) at the
front of the seat. To do this pull the pin out
and rotate through 90 degrees. Carefully
lift the seat and place it into the chassis.
At the rear of the underside of the seat
you will see a receiving channel (B). Place
this securely over the tube (C) towards the
back of the chassis. Pull the handle (D) at
the front of the seat unit up and then pivot
the seat forward and down. Once the front
of the seat is lowered fully, release the
handle and push it forward to ensure it has
fully engaged on the front tube. Rotate the
safety locking pin so it engages in front of
the handle. If it hits the handle then the seat
is not inserted properly, remove and repeat
process outlined above.
7.4 Attaching the seating system to
the Hi-Low or the Easy Chassis.
Always check the handle is fully engaged
before you place the child in the seating
system. If the handle is not engaged
properly the seat unit can come loose and
could cause serious injury to the child or
carer.
B
C
D
A