Summary of WS-BATT-CHRG
Page 1
Accessory ws-batt-chrg battery charger user's manual.
Page 2
Wavesurfer is a trademark of lecroy corporation. Windows is a registered trademark or a trademark of microsoft corporation in the united states and other countries..
Page 3: Foreword
Battery charger user's manual foreword thank you for purchasing lecroy's battery charger. before using this instrument, please read this manual thoroughly to gain a good understanding of it. After reading, please keep the manual in a safe place. this manual describes notes on use and basic usa...
Page 4: Checking The Packing Content
Wavesurfer accessary checking the packing content on delivery of the battery charger, check each item. If any of the items are missing or there is any damage, immediately contact lecroy or the sales office in charge. [items to be present] • ws-batt-chrg (battery charger) ...............................
Page 5: Table of Contents
Table of contents safety requirements ....................................................................... 2 product disposal and recycling ...................................................... 6 overview ......................................................................................... 7...
Page 6: Safety Requirements
Battery charger user's manual safety requirements this section contains information and warnings that must be observed to keep the battery charger operating in a correct and safe condition. You are required to follow generally accepted safety procedures in addition to the safety precautions specif...
Page 7
Wavesurfer accessory operating conditions before using this product, ensure that its operating environment will be maintained within these parameters: temperature: 5 to 40 o c humidity: maximum relative humidity 80 % for temperatures up to 31 o c decreasing linearly to 50 % relative humidity at 40 o...
Page 8
Battery charger user's manual • connect and disconnect properly. Do not disconnect the charge control cable and/or the dc out cable of the battery pack while the battery pack is charged. Doing so may cause the product to malfunction corrupted. • do not use in wet/damp or explosive atmospheres. • for...
Page 9
Wavesurfer accessory connected with a combination other than that shown above. However, if the positive (+) and negative (-) terminals are connected incorrectly, this may cause an electric shock, a fire, or a malfunction. • do not connect a cable or cord, such as ac cable other than that intended fo...
Page 10
Battery charger user's manual product disposal and recycling this electronic product is subject to disposal and recycling regulations that vary by country and region. Many countries prohibit the disposal of waste electronic equipment in standard waste receptacles. For more information about proper...
Page 11: Overview
Wavesurfer accessory overview this product is an optional unit that is specially designed for the oscilloscope and is intended to charge the optional battery pack. This instruction manual describes how to connect this product to the battery pack and how to charge the battery pack. Before using thi...
Page 12: Units
Battery charger user's manual units (a) battery charger figure 2-1 shows the outside view of this product. Top panel side panel front panel side panel rubber foot (4 locations) unit: mm name label rear panel figure 2-1 outside view of battery charger 8.
Page 13: (B) Charge Control Cable
Wavesurfer accessory (b) charge control cable the charge control cable is supplied with the battery charger and it is connected to the battery pack during charging. Figure 2-2 shows the outside view of the charge control cable. Unit: mm figure 2-2 outside view of charge control cable (c) front panel...
Page 14: (D) Rear Panel
Battery charger user's manual (d) rear panel ③ weee label ① ② ④ no. Name description c power power switch on the battery charger. I: power on, o: power off when the power is turned on, the power lamp on the front panel is lit in green. When the power is turned off, the power lamp on the front panel ...
Page 15: Operating Procedures
Wavesurfer accessory operating procedures operate this product using the following procedures. (a) checking the remaining battery charge level of the battery pack 1. An indication switch used to check the remaining battery charge level is provided at the upper portion of the name label of the batt...
Page 16: Charger
Battery charger user's manual (b) connecting the battery pack to the battery charger follow the steps below to connect the ac power cord, dc out cable, and charge control cable. Note 2 before starting the cable connections, always turn off the power switches on the battery pack and battery charger. ...
Page 17
Wavesurfer accessory 3. Connect the charge control cable to the charge control connector at the lower left portion of the front panel of the battery charger. (see figs. 3-4a and 3-4b.) note 4 insert the connector (male) of the cable into the charge control connector (female) firmly. Figure 3-4a conn...
Page 18: Pack
Battery charger user's manual (c) turning on the power switch on the battery pack make sure that the power switch is turned on. If the power switch is off, always turn it on. (see figure 3-6.) green black power switch figure 3-6 power switch on battery pack (d) turning on the power switch on the bat...
Page 19: Control Cable
Wavesurfer accessory (for details, see the section, "charge led lamp indications", on page 15 of the instruction manual for battery pack.) if the remaining battery charge level becomes 80% or more, five charge led lamps are lit in red. Charge the battery pack until all five led lamps are lit in red....
Page 20: Protective Functions
Battery charger user's manual protective functions protective circuits for electrical connection and temperature conditions are provided on this product. Table 4 describes the protective functions and symptoms. If any symptom stated in table 4 occurs, contact lecroy corporation. Table 4 protective...
Page 21: Specifications
Wavesurfer accessory specifications (a) product specifications (1 of 2) item specifications method switching charging method constant current and voltage output voltage 25.2 vdc ±2 % 5.0 a 7 % (during charging) ± output current 0.2 a ± 58 % (during pre-charging) power voltage single-phase, 90 to 2...
Page 22: (B) Product Specifications
Battery charger user's manual (b) product specifications (2 of 2) specifications item operation: +5 °c to +40 °c temperature °c to +60 °c storage (non-operating): −20 operating: maximum relative humidity (rh) 80 % for temperatures up to 31 o c decreasing linearly to 50 % rh at 40 o c. Humidity densa...
Page 23: (C) Certifications
Wavesurfer accessory (c) certifications c declaration of the european council directives based 1997 +a3:2003 emc requirements for : 1994+a1:1995+a2:1997 issions (class a) im meets intent 73/23/eec for product safety and 89/336/eec for electromagnetic compatibility. This declaration is upon complianc...
Page 24
Battery charger user's manual ul and cul listed - conforms to ul 61010-1, 2 nd edition and can/csa c22.2 no. 61010-1-04 20
Page 25
Lecroy corporation 700 chestnut ridge road chestnut ridge, ny 10977–6499 tel: (845) 578 6020, fax: (845) 578 5985 internet: www.Lecroy.Com © 2004 by lecroy corporation. All rights reserved. Lecroy, activedso, probus, jittertrack, wavepro, wavemaster, wavesurfer, and waverunner are registered tradema...
Page 26: Ws-Batt- Chrg
Wavesurfer accessory ws-batt- chrg.