Lectronics LongRanger4 Operating Instructions Manual - page 9
9
Portable Wireless Sound System
Rio Rancho, NM – USA
ANTENNA
BLACK
LEAD
WHITE
LEAD
BLACK
LEAD
SPEAKER
MOUNTING
BLOCK
Add-On
Receiver
BATTERY
Figure 4 - Add-on Receiver Antenna Connections
ADDING A SECOND WIRELESS CHANNEL TO YOUR LONG RANGER
A very popular feature of the Long Ranger is the ability to add a second wireless channel to an existing system in the
field. The Lectrosonics Add-On Receiver system was expressly designed for that purpose. The standard system
consists of an Add-On receiver, an M175 transmitter and a microphone.
The Add-On receiver is supplied with velcro attaching strips and is equipped with the necessary cabling for making
the connections to the Long Ranger. The receiver is installed on the Long Ranger by performing the following steps
as shown in Figure 4:
1) The antenna cable for the Add-On is packed together with screws, lock washers and the velcro strips. The
antenna cable is terminated with two ring lugs. Feed the lug end of this cable through the hole in the Long
Ranger rear panel upright. Dress the cable along the top of the battery pack along with the speaker wires as
shown in Figure 4.
2) Remove and discard the two black Phillips head screws from the bottom of the antenna strip on the right-hand
side of the speaker and from the speaker mounting block. Using the supplied bright screws and lockwashers,
connect the shield ring lug (the black wire) to the speaker mounting block. Connect the center conductor ring lug
(the clear/white wire) to the antenna. Tighten both screws securely.
3) The Add-On receiver is to be mounted on the Long Ranger upright with velcro. The receiver should be posi-
tioned, control panel up, between the horn mounting screw and the screw which secures the battery pack to the
upright. Remove the paper backing from one side of the velcro and affix it to the back of the receiver. Remove
the remaining paper backing and affix the receiver to the upright.
4) Route the antenna cable through the hole in the rear upright panel, above the battery pack so that the black and
white wires reach the speaker mounting block. Connect the remaining two cables to the 12V DC OUTPUT jack
and the LINE input jack on the control panel.