Lectronics uh200 Operating Instructions Manual

Manual is about: frequency-agile plug-on uhf transmitter

Summary of uh200

  • Page 1

    Uh200 frequency-agile plug-on uhf transmitter operating instructions and trouble-shooting guide lectrosonics, inc. Rio rancho, nm.

  • Page 2: Introduction

    Introduction thank you for selecting the lectrosonics uh200 frequency agile, plug-on transmitter. The uh200 combines over 80 years of engineering experience with the very latest components, in a design that addresses the most demanding professional applications. The design of the uh200 was the direc...

  • Page 3

    Frequency agile plug-on uhf transmitter general technical description the uh200 transmitters are comprised of a number of functional sub-systems as shown in the block diagram below. General the 200 system uses 75khz wide deviation for an extremely high signal to noise ratio. The transmitter circuits...

  • Page 4: Controls and Functions

    Controls and functions the uh200 may be used with a wide variety of microphones. The 3-pin xlr connector on the uh200 allows the transmitter to be used with any dynamic microphone, as well as many two wire positive bias lavalier systems (such as those systems supplied by lectrosonics). Input jack st...

  • Page 5: Operating Instructions

    Frequency agile plug-on uhf transmitter operating instructions 1) insert the uh200 into the selected microphone. Listen for the “click” that indicates the uh200 has locked on to the micro­ phone. Pull on the mic to insure proper locking has occurred. To attach to remove pull on mic to insure locking...

  • Page 6: Battery Replacement

    Battery replacement the uh200 transmitter is powered by a standard alkaline 9 volt battery. It is important that you use only alkaline or lithium batteries for longest life. Standard zinc-carbon batter­ ies marked “heavy duty” or “long-lasting” are not adequate. They will provide only about 5 minute...

  • Page 7

    Frequency agile plug-on uhf transmitter receiver rf lamp off 1) transmitter not turned on. 2) transmitter battery is dead. 3) receiver antenna missing or improperly positioned. 4) transmitter and receiver not on same frequency. Display on transmitter and receiver. Check switches/ 5) operating range ...

  • Page 8: Specifications and Features

    Specifications and features operating frequencies: frequency selection: rf power output: pilot tone: frequency stability: deviation: spurious radiation: equivalent input noise: input level: input impedance: input compressor: gain control range: modulation indicators: controls: audio input jack: batt...

  • Page 9: Service and Repair

    Frequency agile plug-on uhf transmitter service and repair if your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the equipment needs repair. Make sure you have followed the setup procedure and operating instructions. Check out the interconnecting co...

  • Page 10: Limited One Year Warranty

    Limited one year warranty the equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was purchased from an authorized dealer. This warranty does not cover equipment which has been abused or damaged by careless handling or shipping. This warr...