- DL manuals
- Lectrosonics
- Transmitter
- HHa
- Instruction Manual
Lectrosonics HHa Instruction Manual
Summary of HHa
Page 1
Rio rancho, nm, usa www.Lectrosonics.Com instruction manual hha handheld transmitter digital hybrid wireless ® us patent 7,225,135.
Page 2
Hha lectrosonics, inc. 2.
Page 3
Wideband hand held transmitter rio rancho, nm 3 consumer alert for us users - fcc order da 10-92 most users do not need a license to operate this wireless microphone system. Nevertheless, operating this microphone system without a license is subject to certain restrictions: the system may not cause ...
Page 4
Hha lectrosonics, inc. 4 general technical description introduction the hha handheld transmitter uses state-of-the-art digital hybrid wireless ® wireless technology, select- able output power and a versatile microphone capsule mounting system to meet the needs of audio profes- sionals and vocalists....
Page 5
Wideband hand held transmitter rio rancho, nm 5 pilot tone squelch the benefit of the pilot tone squelch system is that the associated receiver will remain muted until it receives the pilot tone from the matching transmitter, even if a strong rf signal is present on the carrier frequency of the syst...
Page 6
Hha lectrosonics, inc. 6 a mic capsule is threaded onto the body of the transmitter in the direction shown. Do not overtighten it. The lower housing opens by rotating it in the direction shown. After the threads are disengaged, pull the housing downward until it engages the detent that holds it open...
Page 7
Wideband hand held transmitter rio rancho, nm 7 battery installation to insert batteries, close the eject lever and insert the upper contacts first (closest to the mic capsule). Polar- ity is marked on the label in the bottom of the battery compartment. Close eject lever to install batteries to remo...
Page 8
Hha lectrosonics, inc. 8 battery condition an icon on the main window indicates the remaining power of the transmitter batteries. This battery gauge is most accurate with the typical voltage drop across the life of alkaline batteries. 5 623.400 -40 -20 0 a battery gauge rechargeable batteries give l...
Page 9
Wideband hand held transmitter rio rancho, nm 9 gain this setting is very important since it will determine the audio signal to noise ratio and dynamic range that the wireless system will deliver. Gain must be set accord- ing to the individual voice, the mic capsule in use and the handling technique...
Page 10
Hha lectrosonics, inc. 10 input gain adjustment the two bicolor modulation leds (located at the bot- tom of the control panel) provide a visual indication of the audio signal level entering the transmitter. 5 623.400 -40 -20 0 a the audio level is shown by leds and in the lcd screen. The gain should...
Page 11
Wideband hand held transmitter rio rancho, nm 11 programmable switch functions note: the power and cough functions were added starting with serial number 1001. A special button (the side button) on the outside of the housing can be configured to provide several dif- ferent functions, or to be inoper...
Page 12
Hha lectrosonics, inc. 12 important: be sure to set the attenuator control back to its original setting (“f”) for normal operation. Or a subsequent user may think the unit is malfunctioning or has a poor signal to noise ratio. Lo/mid/hi (bass/mid/treble) - hhvmc only the hhvmc head includes varimic ...
Page 13
Wideband hand held transmitter rio rancho, nm 13 parts and accessories #55008 - blue battery caddy #cchh - zippered pouch padded zipper pouch for handheld transmitter #26872 mic capsule wrench custom wrench for removing windscreen from mic capsule #13585 mic clip screw on mic clip for standard mic s...
Page 14
Hha lectrosonics, inc. 14 firmware update updating the firmware is a simple matter of download- ing a utility program and file from the website and run- ning the program on a windows operating system with the transmitter connected to a computer via the usb port. Go to www.Lectrosonics.Com/us. In the...
Page 15
Wideband hand held transmitter rio rancho, nm 15 step 3: refer to step 1 to return to firmware web page. Down- load firmware update and save to a local file on your pc for easy locating when updating. Step 4: open lectrosonics usb firmware updater. Step 5: update put the transmitter in update mode b...
Page 16
Hha lectrosonics, inc. 16 troubleshooting symptom possible cause transmitter will not power on 1) batteries are inserted backwards. 2) batteries are dead, or too low to be used. Hh modulation leds off 1) audio gain set too low. 2) battery is inserted backwards. Check lcd for power indication. 3) mic...
Page 17
Wideband hand held transmitter rio rancho, nm 17 specifications operating frequencies: † band a1: 470.100 - 537.575 band b1: 537.600 - 614.375 band 606: 606.000 - 631.500 band c1: 614.400 - 691.175 channel step size: normal tuning mode: 100 khz fine tuning mode: 25 khz rf power output: selectable at...
Page 18
Hha lectrosonics, inc. 18 service and repair if your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the equip- ment needs repair. Make sure you have followed the setup procedure and operating instructions. Check the inter- connecting cables and then ...
Page 19
Wideband hand held transmitter rio rancho, nm 19.
Page 20: Limited One Year Warranty
20 03 june 2016 581 laser road ne • rio rancho, nm 87124 usa • www.Lectrosonics.Com (505) 892-4501 • (800) 821-1121 • fax (505) 892-6243 • sales@lectrosonics.Com limited one year warranty the equipment is warranted for one year from date of purchase against defects in materials or workmanship provid...