Lectrosonics LMa Instruction Manual

Other manuals for LMa: Instruction manual, Quick Start Manual
Manual is about: Synthesized UHF Belt-Pack Transmitter Featuring Digital Hybrid Wireless Technology

Summary of LMa

  • Page 1

    Lma frequency-agile uhf belt-pack transmitter featuring digital hybrid wireless ™ technology (us patent pending) instruction manual rio rancho, nm, usa www.Lectrosonics.Com fill in for your records: serial number: purchase date:.

  • Page 2

    Lm/im lectrosonics, inc. Table of contents introduction..............................................................................................................................................................................................4 digital hybrid technology ..............................

  • Page 3

    Frequency-agile uhf belt-pack transmitter rio rancho, nm introduction thank you for selecting the lectrosonics lm or im frequency agile, belt-pack transmitter. The design of these transmitters introduces at a mod- erate cost the advanced technology and features of a lectrosonics belt-pack transmitte...

  • Page 4

    Lm/im lectrosonics, inc. Servo input the lma input is a radically different input system com- pared to previous lectrosonics transmitter microphone inputs. It is so superior that this input system will eventu- ally be utilized by all lectrosonics uhf transmitters. The improvements are audible and ma...

  • Page 5

    Frequency-agile uhf belt-pack transmitter rio rancho, nm audio.Level. Control power.Led antenna input.Jack modulation. Leds power on/off controls and functions input jack the 5-pin (switchcraft ta5f compatible) input accom- modates virtually every lavaliere, hand-held or shotgun microphone available...

  • Page 6

    Lm/im lectrosonics, inc. Battery installation the transmitter is powered by a standard 9 volt bat- tery. We recommend using alkaline or lithium batteries for longest life. Standard zinc-carbon batteries marked “heavy-duty” or “long-lasting” are not adequate. Alkaline batteries provide over six hours...

  • Page 7

    Frequency-agile uhf belt-pack transmitter rio rancho, nm 0 1 2 3 4 5 6 7 8 9 a b c d e f 0 1 2 3 4 5 6 7 8 9 a b c d e f attaching a microphone or musical instrument and adjusting audio levels the front panel modulation leds indicate input level and limiter activity. (see modulation led signal level...

  • Page 8

    Lm/im lectrosonics, inc. Adjusting the transmitter frequency if you are experiencing interference from another signal on your operating frequency, you may need to change the operating frequency of your system. This is done through two frequency select switches located on the left side of the transmi...

  • Page 9

    Frequency-agile uhf belt-pack transmitter rio rancho, nm the wiring diagrams included in this section represent the basic wiring necessary for the most common types of microphones and other audio inputs. Some micro- phones may require extra jumpers or a slight variation on the diagrams shown. It is ...

  • Page 10

    Lm/im lectrosonics, inc. 10 sanken cos-11 microphones, the lectrosonics m150 and other three wire microphones to be used with the sm will require new wiring. If the wiring is not changed, they will have much higher output than usual and extra distortion at high levels. The reason is that the source ...

  • Page 11

    Frequency-agile uhf belt-pack transmitter rio rancho, nm 11 wiring diagram for mi33a instrument cable the mi33ara and mi33ast instrument cable assem- blies allow an optimum match between musical instru- ment pickups and lectrosonics transmitters with 5-pin input connectors. The active preamp and low...

  • Page 12

    Lm/im lectrosonics, inc. 1 troubleshooting it is important that you follow these steps in the sequence listed. Symptom: possible cause: transmitter.Battery.Led.Off. 1. Battery is inserted backwards. When.Power.Switch.“on” 2. Battery is dead. No.Transmitter.Modulation.Leds. 1. Gain control turned all...

  • Page 13

    Frequency-agile uhf belt-pack transmitter rio rancho, nm 1 the fcc requires that the following statement be included in this manual: this device complies with fcc radiation exposure limits as set forth for an uncontrolled environment. This device should be installed and operated so that its antenna(...

  • Page 14

    Lm/im lectrosonics, inc. 1 service and repair if your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the equipment needs repair. Make sure you have followed the setup procedure and operating instructions. Check the interconnect- ing cables and then g...

  • Page 15

    Frequency-agile uhf belt-pack transmitter rio rancho, nm 1.

  • Page 16: Limited One Year Warranty

    Lm/im lectrosonics, inc. 1 january 29, 2007 581 laser road ne • rio rancho, nm 87124 usa • www.Lectrosonics.Com (505) 892-4501 • (800) 821-1121 • fax (505) 892-6243 • sales@lectrosonics.Com limited one year warranty the equipment is warranted for one year from date of purchase against defects in mat...