Ssm micro bodypack transmitter instruction manual rio rancho, nm, usa www.Lectrosonics.Com fill in for your records: serial number: purchase date: quick start steps 1) install a good battery and turn power on (see pages 5 and 8). 2) set the compatibility mode to match the receiver (see page 9). 3) c...
Ssm lectrosonics, inc. 2.
Micro body pack transmitter rio rancho, nm 3 consumer alert for us users - fcc order da 10-92 most users do not need a license to operate this wireless microphone system. Nevertheless, operating this micro- phone system without a license is subject to certain restrictions: the system may not cause h...
Ssm lectrosonics, inc. 4 introduction three block tuning range the ssm transmitter tunes across a range of over 76 mhz. This tuning range covers three standard lectro- sonics frequency blocks. Tuning range block block block four bands are available covering standard blocks as follows: band blocks co...
Micro body pack transmitter rio rancho, nm 5 battery charging the transmitter operates from a 3.7 v rechargeable battery that will provide about six hours of operation per charge. Battery life can be monitored from the timer function built into current lectrosonics receivers. The factory supplied ba...
Ssm lectrosonics, inc. 6 controls and functions modulation leds proper input gain adjustment is critical to ensure the best audio quality. Two bicolor leds will glow either red or green to accurately indicate modulation levels. The input circuitry includes a wide range dsp controlled limiter to prev...
Micro body pack transmitter rio rancho, nm 7 attaching and removing the microphone align the ridges on the plug with the grooves in the jack and insert the plug. Grooves in the jack must align with ridges on the plug slide the threaded sleeve onto the jack and rotate it clockwise to tighten it. Tigh...
Ssm lectrosonics, inc. 8 operating instructions powering on in operating mode press and hold the power button for several seconds until a counter on the lcd progresses from 1 through 3, followed by a display of the model, firmware version, frequency block and compatibility mode. When you release the...
Micro body pack transmitter rio rancho, nm 9 setup screens down button menu hold the down button while powering up the unit. Then press the audio button repeatedly to scroll through the following settings. Use the up and down arrows to select the available options under each setting. • rc - remote c...
Ssm lectrosonics, inc. 10 microphone wiring looking into the 3 pin lemo mic connector from the outside of the transmitter, the pin centered in the two guide slots is pin 1 (ground). Pin 2 is a 1k resistor to ground. Pin 3 is the audio/bias connection for two-wire microphones and line inputs. Pin 1 p...
Micro body pack transmitter rio rancho, nm 11 remote control remote control signals (“dweedle tones”) may be used to control the transmitter. The tones are played back into the microphone to avoid the need to reach and handle the transmitter when making changes to the following adjustments and setti...
Ssm lectrosonics, inc. 12 lectrorm by new endian llc lectrorm is a mobile application for ios and android smart phone operating systems. Its purpose is to make changes to the settings on select lectrosonics transmit- ters by delivering encoded audio tones to the micro- phone attached to the transmit...
Micro body pack transmitter rio rancho, nm 13 accessories rechargeable battery p/n 40106-1 lb-50 3.7v lithium-ion battery pack battery charger p/n 40102 charger for lectrosonics lb-50 battery antenna downward belt clip p/n 26995 slide-on belt clip antenna upward belt clip p/n 27079 slide-on belt cli...
Ssm lectrosonics, inc. 14 firmware update updating the firmware is a simple matter of download- ing a utility program and file from the website and run- ning the program on a windows operating system with the transmitter connected to a computer via the usb port. Go to www.Lectrosonics.Com/us. In the...
Micro body pack transmitter rio rancho, nm 15 step 3: refer to step 1 to return to firmware web page. Down- load firmware update and save to a local file on your pc for easy locating when updating. Step 4: open lectrosonics usb firmware updater. Step 5: put the transmitter in up- date mode by simult...
Ssm lectrosonics, inc. 16 specifications operating frequencies: band a1: 470.100 - 537.575 band b1: 537.600 - 614.375 band c1: 614.400 - 691.175 band d1: 691.200 - 767.975 (export only) frequency selection steps: selectable; 100 khz or 25 khz rf power output: selectable; 25 or 50 mw pilot tone: 25 t...
Micro body pack transmitter rio rancho, nm 17 service and repair if your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the equipment needs repair. Make sure you have followed the setup procedure and operating instructions. Check the interconnect- in...
Ssm lectrosonics, inc. 18.
Micro body pack transmitter rio rancho, nm 19.
16 june2016 581 laser road ne • rio rancho, nm 87124 usa • www.Lectrosonics.Com (505) 892-4501 • (800) 821-1121 • fax (505) 892-6243 • sales@lectrosonics.Com limited one year warranty the equipment is warranted for one year from date of purchase against defects in materials or workmanship provided i...
