Led Lenser NEO Operating Instructions Manual - page 15
Led Lenser®
*
EN Operating instructions NEO_V.01 | 7/31/2014
15
5.5 Replacing the Batteries
The battery box ① is located at the rear of the headlamp for
optimal weight distribution.
1. Pull back the flexible battery cover ② of the battery box
① on the side labeled ”Open” to replace the batteries.
2. Carefully pull out the battery box ① and cable ④ from
the battery cover ② and twist the battery box ①.
3. Removed the empty batteries and dispose of them in
accordance with national legislation.
4. Insert the new batteries ⑤ in accordance with the (+/-)
markings in the battery box ①.
5. Push the battery box ① into the battery cover ⑥ while
inserting the cable attachment into the corresponding
opening ③ of the battery cover ②.
6. Put the flexible battery cover ② over the battery box ①
on the side marked with ”Open”, slightly depressing the
cover ② such that it closes flush.
1
CAUTION
EXPLOSION HAzARD
Always insert the batteries according to the
(+/-) markings as there is otherwise a risk of
damaged or even exploding batteries.
5.6 Cleaning
The following should be noted for cleaning:
•
Clean the headlamp and its accessories only dry using a
lint-free cloth.
•
If the headlamp comes into contact with salt water, remove
the salt water immediately and fully with a lint-free cloth.
•
Wash the headband in clear water and let it dry before use.
•
Do not use any chemical or solvent-based detergents or
disinfectants.
ATTENTION
DAMAGE TO SURFACES
Solvents can damage surfaces or decompose
materials!
Therefore:
•
Do not use any cleaning agents or disinfectants.
•
Do not use scouring agents.
•
Do not use gasoline, paint thinners or similar
products.
5. Operation
2
1
3
4
1.
4.
2.
3.
2
5
1