Led Lenser P6X Operating Instructions Manual - page 9
Led Lenser®
*
3. Safety Notes
EN Operating instructions P6X_V.01 | 7/31/2014
9
NOTe
eLeCTROMAGNeTIC COMPATIBILITY
The flashlight meets the requirements of the 2014/30/EC guideline with
regard to electromagnetic compatibility.
Modifications / Repairs
CAUTION
DO NOT MAKe ANY MODIFICATIONS/RePAIRS
Repairs, additions or modifications to the flashlight are not permitted
as these may lead to damages to the flashlight or a risk to persons:
Therefore:
•
LEDs cannot be replaced.
•
Do not open the flashlight unless this is expressly permitted by the
operating instructions.
•
Never carry out repairs yourself, always take the flashlight to a specialist
dealer.
Batteries and battery packs
WARNING
eXPLOSION OR RISK OF ACID BURNS
Batteries/battery packs can explode as a result of strong
heating. Leaking of battery fluid can cause chemical burns.
Therefore:
Do not expose batteries and battery packs ...
•
To direct sunlight or great heat over an extended period of time,
•
Do not heat them or throw them into the fire and avoid heat buildup in
the flashlight by covering it, for instance,
•
Do not throw them into water or leave out in the rain,
•
Do not swallow them,
•
Do not open, damage or short-circuit them,
•
Only recharge them if they are labeled accordingly,
•
Do not store them within the reach of children,
•
Only insert them into the battery compartment in accordance with the
displayed markings (+/-),
•
Should be removed from the flashlight if you will not be using it for some
time or if they are empty.
What to do:
→
In the event of leaking batteries, place a cloth underneath and prevent
the skin, eyes and mucous membranes from coming into contact with
battery fluid. In the event of contact, immediately rinse the affected parts
with plenty of clean water and consult a doctor.
ATTeNTION
CHANGING THe BATTeRY
•
Store batteries/battery packs in a clean, dry place between -10 °C and
+25 °C.
•
Only insert batteries/battery packs in accordance with the markings
(+/-).
•
If necessary, clean the battery/battery pack and/or flashlight contacts
before inserting.