Led Pro LEDJ231 User Manual - page 5

 Pro White LED Matrix Block 

                                                                Operation Modes

Operation modes

Sound Active mode:

To activate the unit in sound active mode, press the

 “MODE” button to show “SOUND  MODE” 

on the LCD screen. Now press the 

“SET UP” button to select the desired sensitivity level by using 

the 

“UP” and “DOWN” buttons. Press the “SET UP” button again to select the frequency level 

and adjust by using the 

“UP” and “DOWN” buttons.

“SENS” 00 - 31 (00 = low, 31 = high)

“FQN” 01-99 (01 = low, 99 = high)

Auto run mode:

To activate the unit in auto run mode, press the

 “MODE” button to show “AUTO RUN” on the 

LCD screen. Now press the 

“SET UP” button to select the desired frequency level by using the 

“UP” and “DOWN” buttons.

“FQN” 01-99 (01 = low, 99 = high)

Note: In this mode, it will run 14 built-in programmes in a continious loop.

Slave mode:

To activate the unit in slave mode, first you must link multiple units together and press the

“MODE” button to show “SLAVE MODE” on the LCD screen. Now on the master unit press the 

“MODE” button to select the desired mode and the slave units will now run in sequence with the 

master unit.

Built-in programmes:

To activate the units built-in programmes, press the 

“MODE” button to show “01.STATIC” on the 

LCD screen. Press the 

“SET UP” button to choose between the 14 built-in programmes by 

using the 

“UP” and “DOWN” buttons. Now press the “SET UP” button to select the desired 

speed and adjust by using the 

“UP” and “DOWN” buttons. Press the “SET UP” button once 

more to select the desired flash value and adjust by using the 

“UP” and “DOWN” buttons.

Speed values: 00 - 99 (00 = slow, 99 = fast)

Flash values: 00 - 99 (00 = slow, 99 = fast)

For the 14 built-in programmes please see page 5.

DMX mode:

To activate the unit in DMX mode, press the 

“MODE” button to show “DMX MODE” on the LCD 

screen. Press the 

“SET UP” button and select the desired DMX address setting by using the 

“UP” and “DOWN” buttons. Then to select one of the 3 DMX modes 3, 16 or 19 channel,

press the 

“SET UP” button again to choose the desired DMX mode by using the “UP” and 

“DOWN” buttons.

For the 3, 16 or 19 channel DMX address information please see pages 6 & 7.

NOTE: Once the desired settings have been selected in each of the above modes, 

ALWAYS

            confirm the settings by pressing the

 “SET UP” button.

4.