Ledco DS.GD8 User Manual

1.  CONNECTING LAPTOP TO DS.GD8 SERIES DOCKING STATION

2.  POWERING DS.GD8 SERIES DOCKING STATION

     WITH THE LAPTOP INSTALLED

Toggle the on/off switch 

to the ON position.

(Left side pushed in

indicates ON position)

The green LED on the left side will indicate the DS.GD8 is

powering correctly, and the green LED on the right side

indicates that your laptop is connected to the DS.GD8

correctly and communicating with the docking station.

If you try to connect laptop to the DS.GD8 while the mounting clamps

are engaged, you will need to press in barrel lock button to disengage

the clamps before proper connection can be made

NOTE

Fit laptop into the 

front mounting bracket.

A.

A.

Lower the back end

of laptop into place

and press down.

B.

B.

Pull the front latching

lever forward to engage

the mounting clamps.

Check that laptop is

securely mounted by

pulling up on the laptop.

If it moves, repeat

steps B and C.

C.

1.877.875.5524

www.LEDCO-CHARGEGUARD.com/GD8Dock

GD-0026-IS-A

         Additional mounting screws and keys are included in the attached Hardware Kit

Computers not equipped with pass-through RF antennae should not be used on

DS.GD8 Docking Stations that are equipped with RF pass-through antennae.

Using this combination together can result in the chance that the on-board antenna circuit

in the computer could be damaged if exposed to sustained high vibration.

DS.GD8 Docking Station 

User Guide

Compatible with General Dynamics-Itronix GD8000 & GoBook   XR-1 Laptops