LedGlow Advanced 3 Million Wireless USB Truck Underbody Kit Installation Instructions Manual
Advanced 3 Million Wireless USB Truck Underbody Kit
Warning:
Please check your state and local laws before installing this LED underbody kit. Every state has different policies and procedures in
place regarding aftermarket vehicle accessories. LEDGlow is not responsible for any fines that you may receive while using this underbody kit.
This kit is for off road use only.
Warning:
The installation of this kit is recommended to be installed by a licensed professional. The improper installation of this kit will void
all warranties.
The control box that is used to power the underbody tubes must be installed in a dry location! Having this part exposed to water or the
elements will cause the kit’s controller to fail. Any water damage or corrosion to this part will VOID all warranties.
PLEASE READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE INSTALLING AND OPERATING THIS LED
UNDERBODY KIT.
Truck Underbody Kit Includes:
(2) 48 Inch Tubes
(2) 36 Inch Tubes
(2) 24 Inch Tubes
(1) Control Box
(1) USB Hub
(1) Wireless Remote
(14) Mounting Brackets
(25) Zip Ties
(30) Large Screws
Underbody Kit Installation:
1.
Arrange the tubes out on the ground and test the kit to ensure proper functionality before installing.
2.
Before mounting the underbody tubes, please refer to the schematic below. The underbody tubes on this kit must be
installed in a specific way. This ensures all lighting patterns are properly synchronized and displayed correctly.
Note: The tubes can be plugged into any of the ports on the USB hub and will not affect the patterns.
3.
Optional: Raise and support the vehicle.