Ledj INTENSE 12D4 CW User Manual - page 5

 LEDJ Intense 12D4 CW/WW LED Slim Panel   

                                                    Operations

DMX mode:

To access the DMX mode, press the 

“MODE” button on the LED display to show “d001” on the 

LED display. Now press the 

“ENTER” button and use the “UP” and “DOWN” buttons to set the 

desired DMX address setting from 

“d001 - d512”.Once you have selected the desired DMX 

address setting, press the 

“ENTER” button to choose one of the 2 or 4 DMX channel modes use 

the 

“UP” and “DOWN” buttons and press the “ENTER” button to confirm the setting.

Built-in programme mode

To access the static colour mode, press the 

“MODE” button on the LED display to show “Pr01” 

on the LED display. Now use the 

“UP” and “DOWN” buttons to scroll the built in programmes 

from Pr01 to Pr04.

To change the speed of the selected programme, press the 

“ENTER” button and use the “UP” 

and 

“DOWN” buttons to set the speed from 00 to 99. To add strobe press the “ENTER” button 

again and use the 

“UP” and “DOWN” buttons to set strobe from 00 to 99. To confirm your setting 

press the 

“ENTER” button. Note: 00 = slow, 99 = fast.

In 

“Pr01” you can set a specific static colour. When in Pr01, press the “ENTER” button and use 

the 

“UP” and “DOWN” buttons to scroll through the list of built-in static colours.

0 = Off 

1 = Cool White 

2 = Warm White 

3 = Cool white & Warm White 

To adjust the brightness of the selected colour, press the 

“ENTER” button and use the “UP” and 

“DOWN” buttons to to increase or decrease the brightness from 000-255. 

Note 000 = Off 255 = full on.

To add strobe press the 

“ENTER” button again and use the “UP” and “DOWN” buttons to set 

strobe from 00 to 99. To confirm your setting press the 

“ENTER” button. 

(00 = slow, 99 = fast)

Auto run mode

To access the auto run mode, press the 

“MODE” button on the LED display to show “AUTO” on 

the LED display. The unit will run through all of its built-in programmes.

Master/slave mode

To set the unit as the master, simply use any of the above modes.

To set the unit as a slave unit(s), press the 

“MODE” button on the LED display to show “SLAv”

on the LED display. Now the unit will follow in sequence with the master unit.