Order code: ledj186 uv 50w cob flood 1 x 50w uv cob led user manual optional ir remote order ref: ledj90e.
Www.Prolight.Co.Uk uv 50w cob flood user manual 2 safety advice warning for your own safety, please read this user manual carefully before your initial start-up! • before your initial start-up, please make sure that there is no damage caused during transportation. • should there be any damage, consu...
Www.Prolight.Co.Uk uv 50w cob flood user manual 3 product overview & technical specifications this powerful 50w uv flood will fill a variety of venues with an outstanding uv glow. These units have a rugged, metal housing and measure only 130mm in depth for easy transportation and installation. They ...
Www.Prolight.Co.Uk uv 50w cob flood user manual 4 01 - bracket 02 - bracket tightening knobs 03 - earth point 04 - led display 05 - function buttons 06 - dmx input socket 07 - dmx output socket 08 - iec power in socket 09 - iec power out socket 10 - fuse f1a 250v 08 10 09 03 07 06 enter down mode up...
Www.Prolight.Co.Uk uv 50w cob flood user manual 5 operating instructions dmx channel mode: to access the dmx channel mode, press the “mode” button on the rear of the unit to show a001 on the led display. Now press the “enter” button and use the “up” and “down” buttons to set the desired dmx address....
Www.Prolight.Co.Uk uv 50w cob flood user manual 6 operating instructions & dmx setup included ir remote functions: button functions: dmx address examples: to set the dmx address; • press the “s” button, the led fixture will illuminate in full, you can now start to set the dmx address • select the re...
Www.Prolight.Co.Uk uv 50w cob flood user manual 7 dmx 512: dmx (digital multiplex) is a universal protocol used as a form of communication between intelligent fixtures and controllers. A dmx controller sends dmx data instructions form the controller to the fixture. Dmx data is sent as serial data th...
Www.Prolight.Co.Uk uv 50w cob flood user manual 8 special note: line termination: when longer runs of cable are used, you may need to use a terminator on the last unit to avoid erratic behaviour. Using a cable terminator will decrease the possibilities of erratic behaviour. (3-pin - order ref: cabl9...
