Ledj LEDJ280 User Manual - Operating Instructions
www.prolight.co.uk
Spectra Flood 24T9 User Manual
8
Built-in program mode:
To access the built-in program mode press “MODE” until the display shows
Pr.01
on the LED display.
Press “ENTER” to confirm the setting. Use the “UP” and “DOWN” buttons to select a program from
Pr.01
~
Pr.10
. Press the “ENTER” button to confirm the setting.
To change the speed of the selected program press the “ENTER” button and then use the “UP” and
“DOWN” buttons to select any value from
SP00
~
SP99
. Press the “ENTER” button to confirm the
setting, then use the “UP” and “DOWN” buttons to select and value from
F500
~
F599
for the
strobe feature. Press the “ENTER” button to confirm the setting.
In
Pr.01
you are able to set a specific static colour. When in
Pr.01
press the “ENTER” button and
then use the “UP” and “DOWN” buttons to go through the static colours. Press the “ENTER” button to
confirm the setting, then use the “UP” and “DOWN” buttons to select and value from
F500
~
F599
for the strobe feature. Press the “ENTER” button to confirm the setting.
To exit out of any of the above options, press the “MODE” button.
Master/slave mode:
To set the master unit, press the “MODE” button on the rear of the master unit then select your desired
program (sound active, auto, static colour or one of the built-in programs). To set the other units in slave
mode, press the “MODE” button on the rear of the unit to show
SLAU
on the LED display and press
the “ENTER” button to confirm the setting. The units will now run in sequence with the master unit.
To exit out of any of the above options,
press the “MODE” button.
Please ensure that all slave units are set to the
same DMX channel mode as the master unit.
Auto mode:
To access the auto mode press “ENTER” until the display
shows
Auto
on the LED display. The fixture will now
run through its built in programs
Pr.02
~
Pr.10
.
To exit out of any of the above options, press the “MODE”
button. NOTE: The user can set up the speed and flash
speed for
Pr.02
~
Pr.10
under the built in programs
mode. Changing this here will then take effect when
running auto mode.
Operating instructions
Pr.01
Static colour
Pr.02
7 colour fade
Pr.03
3 colour fade
Pr.04
7 colour change
Pr.05
3 colour change
Programs:
Static colours:
Pr.06
Dynamic colour fade 1
Pr.07
Dynamic colour fade 2
Pr.08
Red continous fade
Pr.09
Green continous fade
Pr.10
Blue continous fade
Built-in program
Pr.01
Static colour
Pr.02
7 colour fade
Pr.03
3 colour fade
Pr.04
7 colour change
Pr.05
3 colour change
Pr.06
Dynamic colour fade 1
Pr.07
Dynamic colour fade 2
Pr.08
Red continous fade
Pr.09
Green continous fade
Pr.10
Blue continous fade
SP00
~SP99 (speed)
F500
~F599 (flash)
Auto mode
AUTO
Slave mode
SLAV
DMX mode
1CH, 3CH, 4CH, 6CH
Address setting
A001
~A512
Menu system
1.--r
- Red
2.-rg
- Yellow
3.--g
- Green
4.-gb
- Cyan
5.--b
- Blue
6.-rb
- Pink
7.rgb
- White
8.off
- Blackout