Ledj RGB-1 User Manual - page 5
Features:
For use with LEDJ Tri colour, 6 channel fixtures.
7 hold colour buttons for instant colour selection, each colour with dimming control.
4 selector buttons for Colour chase, Colour fade, Manual and Sound active.
Sound active function with adjustable sensitivity.
Blackout & Strobe functions.
Operation:
When you power up your RGB-1, it will show
“BLACKOUT” mode.
Please make sure that your LEDJ fixture is set to DMX address 001 to work with this controller.
You are now ready to select any of the following modes for operation.
1, Colour Selection mode
In this mode you can select the colour using one of the seven preset buttons, you must use the
“MASTER DIMMER” slider to set the desired brightness.
2, Sound Active mode
In this mode you can have a seven colour chase activated by the internal microphone. You will
need to adjust the
“SENSITIVITY” slider to set the music input sensitivity level. You can then use
the
“MASTER DIMMER” slider to set the desired brightness.
3, Manual mode
To set the RGB-1 into Manual mode, press the
“MANUAL” button so the above LED
illuminates. Now you can
create almost any colour by using any one of the “RED, GREEN and
BLUE” sliders.
3a, Colour macro slider
To select a built-in static colour, colour chase or colour fade use the
“COLOUR MACRO” slider.
To change the brightness of any of the modes simply use the
“MASTER DIMMER” (0-100%) and
if you wish to add a strobe to your selection, simply use the
“STROBE SPEED” slider (slow-fast).
4, Colour Fade mode
To set the RGB-1 into Colour fade mode, press the
“FADE” button so the above LED
illuminates. The unit will now fade through all colours. To adjust the speed of the fade simply
adjust the
“SPEED” slider to the desired level. To set the brightness level, simply use the
“MASTER DIMMER” slider (0-100%).
5, Colour Chase mode
To set the RGB-1 into Colour chase mode, press the
“CHASE” button so the above LED
illuminates. The uint will now chase through all colours. To adjust the speed of the chase simply
adjust the
“SPEED” slider to the desired level. To set the brightness level, simply use the
“MASTER DIMMER” slider (0-100%).