Ledj VersiLED 4 User Manual - Operating Instructions
www.prolight.co.uk
VersiLED 4 DMX Controller User Manual
5
Fader allocation VS Mode chart:
04) Run mode select (auto or sound):
The built-in colour macro’s may be triggered by either sound control or auto with speed control.
Press the Run Mode button to change between sound or auto control. The LED indicator will
illuminate to show the Run Mode. Use the speed and sound sensitivity faders to adjust the auto
speed or sound sensitivity.
05) Blackout button:
The blackout control can be used for instant blackout (off) commands of the fixtures controlled by the
VersiLED 4 controller. The blackout button is a global command and will control the fixtures regardless
of any fixture/group selection.
Press and hold the blackout button to enable the Master Dimmer function and at the same time use the
strobe speed/dimmer fader to control overall intensity of the dimmer channels. This will also function as
a global command and will control the fixtures regardless of any fixture/group selection.
06) Strobe button:
Press and hold the Strobe button to activate a white strobe across the fixtures selected on the fixture/
group. While holding the button, the strobe speed can be adjusted using the strobe speed/sound
sensitivity/dimmer fader. The strobe speed is adjustable 1Hz-20Hz. Please note: If the master dimmer
function has been set to zero then the strobe will not operate. Please set the master dimmer back up for
the strobe to function again.
07) RGBW colour mix:
The RGBW colour mix fader can be used for rapid selection of static colours. Push the fader to fade from
Red, through Green and Blue up to full on at the upper limit of the fader.
08) Colour macro fader:
The VersiLED 4 controller has built in RGB colour macro’s that can be triggered by sound with
adjustable sensitivity or auto with speed control. Select the desired fixture/groups and then use the
macro fader to select from one of the eight internal colour macros. The auto speed can be set using
the speed fader, while the sound sensitivity can be set using the strobe speed/sound sensitivity/master
dimmer fader.
Operating instructions
Mode
Fader 1
Fader 2
Fader 3
Fader 4
DMX Allocation
M1
RGB
Red
Green
Blue
-
RGB
M2
RGBD
Red
Green
Blue
Dimmer
RGB + CH4 Master Dimmer
M3
RGBW
Red
Green
Blue
White
RGBW
M4
RGBWD
Red
Green
Blue
White
RGBW + CH5 (fixed at 255)
M5
DRGB
Red
Green
Blue
Dimmer
Dimmer + RGB
M6
DRGBW
Red
Green
Blue
White
RGBW + CH1 (fixed at 255)