Ledj Xterior Wash Tri User Manual - page 5
There are 5 different operation modes to choose from:
1) Static colour mode
2) Colour change mode 3) Colour fade mode
4) Slave mode
5) DMX mode
1, Static colour mode
Mode button - Press the “MODE” button under the LED display, to show “C000”, then press the
“SET UP” button to choose one of the static colours using the “UP” and “DOWN” buttons.
The Colours range from:
1, “C100” = RED, 2, “C200” = Green, 3, “C300” = Blue,
4, “CF00” = Strobe
Now press the
“SET UP” button again and you can then select the brightness output using the
“UP” and “DOWN” buttons.
The light output settings are from 00-99 (00 = off, 99 = full)
The strobe speed settings are from 00-99 (00 = slow, 99 = fast)
2, Colour change mode
Mode button - Press the MODE button until the LED display shows “J000”, then press the “SET
UP” button to choose one of the colour changing modes using the “UP” and “DOWN” buttons.
The colour change programmes are as follows:
1, “J300” = RGB, 2, “J700” = 7 colour,
3, “JF00” = Strobe,
Now press the
“SET UP” button again and you can then select the colour change speed using the
“UP” and “DOWN” buttons.
The speed settings are from 00-99 (00 = slow, 99 = fast)
3, Colour fade mode
Mode button - Press the MODE button until the LED display shows “F000”, then press the “SET
UP” button to choose one of the colour changing modes using the “UP” and “DOWN” buttons.
The colour fade programmes are as follows:
1, “F300” = RGB, 2, “F700” = 7 colour,
3, “FF00” = Strobe,
Now press the
“SET UP” button again and you can then select the colour fade speed using the
“UP” and “DOWN” buttons.
The speed settings are from 00-99 (00 = slow, 99 = fast)
4). Slave mode
Link the units together using a 3-pin DMX cable, then press the
MODE button to select one of the
above modes. On the Slave units press the mode button until the LED display shows
“SLAV”. The
Slave units will then follow in sequence with the Master unit.
5). DMX Addressing mode
To access the DMX address mode, press the
MODE button until the LED display shows “A000”,
then press the
“SET UP” button and set the first digit in the DMX address using the “UP” and
“DOWN” buttons. Now repeat this step to set the second and third digits for the desired DMX
address setting.
Follow the DMX channel assignment and function table overleaf.
Note: Always press the “SET UP” button a fourth time to confirm the setting in each
of the above modes.
Xterior Wash Tri
Operation