Leema-acoustics STREAM Handbook - Stream
WARNING:
To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture. Do not use in
damp conditions. Do not place objects containing liquids, drinks or vases for example, on the unit.
Do not open the cabinet. Refer to qualified service personnel only.
WARNING
CLASS 1
LASER
PRODUCT
This appliance is classified
as a CLASS 1 LASER
product. Do not open the
cabinet as the laser beam
used in this appliance is
harmful to eyes.
Disposal of Electronic Equipment in the European Union and
other countries with collection procedures:
The wheelie bin symbol on this product indicates that it shall not
be treated as household waste. It should be disposed of via a
collection point for the recycling of electrical and electronic
equipment.
Mains Supply Voltage:
This unit may be set to operate on 220-240 VAC or 110-120 VAC 50/60 Hz by inserting the rear
panel fuse holder in the appropriate orientation. This setting should only be changed by an authorised service agent as an
inappropriate setting will damage the unit. Before use, check that the unit’s voltage setting displayed above the IEC mains
inlet matches the mains power supply in your area.
Disconnect the mains supply if the unit will not be used for a long period of time.
Cleaning:
Disconnect the unit from the mains supply. Clean the cabinet, front panel and lid with a soft cloth slightly
moistened with a weak detergent solution or clear fluid glass cleaning product. Ensure the unit is fully dry before re-
connecting the mains supply. Do not re-connect the supply with damp hands.
Do not use any abrasive or solvent based cleaning products as these will damage the finish.
Placement:
Operate the unit on a flat and level hard surface. To prevent the build-up of heat inside the player, place the
unit in a location with adequate ventilation and do not cover the unit. Do not locate the unit near heat sources such as
radiators or in direct sunlight. Do not move the player with a disc inside. This disc may be damaged or may fall inside the unit.
Condensation:
If the unit is moved from a cold location to a warm room, condensation may occur on the laser optics
causing a temporary malfunction. The unit will return to normal operation after a short period of time.
3