1. DL manuals
  2. Leetek
  3. Pager
  4. LTK-1100H
  5. User Manual

Leetek LTK-1100H User Manual

Manual is about: PAGER TRANSMITTER

Summary of LTK-1100H

  • Page 1

    Ltk-1100h pager transmitter (ltk-1100h) user manual www.Leetek.Org leetek2001@yahoo.Co.Kr lee technology korea.Co.,ltd(leetek) 3 rd #499-2 sang3dong, wonmi-gu, puchon-city, kyunggi-do, korea t:82-32-324-9838/9 f:82-32-324-9840 fcc id :qbtltk-1100h trade name :pager transmitter model no. :ltk-1100h t...

  • Page 2

    Important safety information rf exposure statement your pager transmitter contains a radio frequency transmitter. When the button is pushed the transmitter sends our rf signals. Caution: to comply with fcc rf exposure compliance requirements, a separation distance of at least 8 inches (20 cm) must b...

  • Page 3: User Manual

    User manual specification z pocsag code z carrier frequency : 457.5750mhz +/- 200hz z frequency range: 450.0000 ~ 467.8750mhz z fm modulation & fsk (frequency shift keying) z deviation: 4.5khz z fm accuracy : +/-5% 4.275 z date rate: 1200bps, 600hz +/-5hz z output power : 2w z message: numeric: max....

  • Page 4

    You can use your transmitter with the 20 degree wedge attached or remove the wedge and lay the transmitter flat. 2) wall mount to mount your transmitter on a wall z remove the plastic bracket (included) under the transmitter unit by unlocking the 2 latches. Z place the plastic bracket against the wa...

  • Page 5

    To enter programming mode, press the “setup” button and enter the password “1379” followed by “enter”. If the password is accepted, the display will show “use * to scroll to menu options”. (use the “ ∗ / menu” key to scroll through the different menu options or press “cancel” to exit the system prog...

  • Page 6

    The charger bases. Z at the “set pager alert” menu, press the “#/select” key to scroll through the different alert options. Z after making a selection, press the “enter” key 3 times. After sending the code, the coasters will now respond with your new selection. Z press “cancel” key to exit the syste...

  • Page 7

    • press “enter” key 3 times. After sending the signal, all the coasters will light up once to tell you that they received the new code. • press “cancel” key to exit the system programming menu. To test the coasters with out of range off, unplug the power supply that is connected to the transmitter. ...

  • Page 8: Warranty

    Will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ● reorient...

  • Page 9: I Do?

    I need to send some transmitter in for repair - what do i do? Within warranty period / covered by our product-care program: ship malfunctioning components to the following address: 3 rd fl, #499-2 sang 3-dong, wonmi-gu, puchon-city, kyunggi-do, korea tel: 82-32-678-8605 fax: 82-32-324-9840 1. Pack t...