Legacy Fire Pit Owner's Manual - page 5
With the top assembled, insert the gas burner
pan and fill with the media that comes with your
unit [lava rock] or an optional media you
purchased. Follow all gas connection instructions
on the following page. Media must be installed
for the burner to function properly. Lack of
media will result in very low burner flame and
possible damage to the burner.
Attach the 36” hose with regulator to the Valve assembly located in the
inside of you Fire Pit. Attach the 24” connector hose to the outlet
side [look for the flow direction arrow] of the Valve assembly.
Attach the 24” connector hose now connected to the valve
assembly to the end of the brass orifice and place stainless burner
into the top of the Fire Pit. Note: Be sure that all fittings are
secure and will not result in any leaks.
Open the bag of Lava Rock and spread evenly over the complete
stainless steel burner surface.
Connect the Regulator to a propane gas tank.
Open your propane gas tank valve. Note: Be sure that the valve in your Fire Pit is in the Off position prior to
opening your propane gas. Then, using the key supplied turn the gas on slowly and ignite using a butane lighter
or long fireplace match, after ignition adjust the flame to the desired height
Important:
Do not operate indoors or in any enclosed location
This product is for outdoor use only
This product is for propane use only.
If you wish to use Natural Gas contact your dealer for the conversion.
If you smell gas, immediately shut the fire pit off and test your connections.
If you continue to smell gas call you dealer.