Legacy LCD35 Instruction Manual - page 4
Page 3
Page 4
9. SKIP TRACK UP/ FAST REVERSE BUTTON
In CD playback state, press the button briefly to play the next track.
Press and hold the button to fast forward, the CD playback stats when
release the button.
10. SKIP TRACK DOWN / FAST REVERSE BUTTON
In CD playback state, press the button briefly to play the previous track.
Press and hold the button to fast reverse, the CD playback starts when
release the button.
11. CD EJECT BUTTON
In power supply on state, the loaded CD can be ejected by pressing the
button.
12. TUNING CONTROL
In RADIO mode, rotate this tuning knob to set the dial pointer against the
station frequency as desired within FM/AM.
13. MON/INT BUTTON
MONST MODE: (This operation is effective on FM reception only.)
In RADIO mode, press this button briefly to change between mono and
stereo modes. The character ST will be visible on the display while there is
a strong signal from an FM station that is broadcasting in stereo.
Mono improves the reception of the distant stereo FM stations.
INT MODE:
In CD playback state, press this button briefly to play the first 10 seconds of
each track on the current disc. The character INT appears on the display.
Press again to exit the INT mode and resume CD playback when you locate
your desired track.
14. LOC/RDM BUTTON
LOCAL /DISTANT MODE: ( This operation is effective on FM reception only.)
In RADIO mode, press this button briefly to change between local and distant
reception. Pressing this button briefly will improve reception in some areas
where the signal is too strong. The character LOC will appears on the display
indicating you are in the local reception mode. press again to release it to
improve distant reception when you are located in an area with a weak signal.
Use of this button toggles between local and distant FM reception.
RDM MODE:
IN CD playback state, press this button briefly for random playback mode.
The character RDM appears on the LCD display, then press the button
to play the entire track on the current disc in random order, press again to
cancel this RDM playback mode.
( NOTE: When the LCD display still display CD playback logo after
ejecting a disc, and it may occur incapable load CD, then you can press the
button to resume normal.)
15. MODE/LOUD BUTTON
MODE BUTTON:
(1) When there is a disc in the CD compartment, press this button briefly to
change between CD and RADIO mode each other. The LCD display will
appears radio reception status when you change it to radio mode; The
LCD display will appears CD playback status when you change it to CD
mode.
(2) When there is no a disc in the CD compartment, this button has not the
function of mode changing.
LOUD BUTTON:
Press this button briefly to enhance the bass output while the volume level
is low. The character LUD will be visible on the display.
Press again to cancel loudness effect.
16. BAND/RPT BUTTON
BAND BUTTON:
In RADIO mode, press this button briefly to change between AM and FM.
The corresponding character of band which has been selected will appear
on the display.
RPT MODE:
In CD playback state, press this button to repeat play the current track.
The character RPT will be visible on the display. Press again to stop repeat.
WIRING DIAGRAM
Note:
If you have 2 speakers system, use 4 ohm impedance loudspeaker;
If you have 4 speakers system, use 8 ohm impedance loudspeaker
to reduce the distortion during high volume level.
£ ¢ £ ¢
£ ¢ £ ¢
LEFT
LOUDSPEAKER
+
GRAY/BLACK
GRAY
-
ANTENNA PLUG
BLACK(GND)
IGNITION SWITCH
RED (B+)
BLUE AUTO ANT
FUSE 3A
GREEN/BLACK
GREEN
RIGHT
LOUDSPEAKER
RCA LINE OUT
RED R
WHITE L
+
-