Legacy Luminance Owner's Manual - page 19
_____________________________________
USING LUMINANCE (cont.) 19
E. SPEAKER MODE SET-UP FOR FRONT,
CENTER, REAR and SUBWOOFER
1. Press SPEAKER SET button first then you will see the
indicator in the center of this button will light up.
2. Press buttons FRONT, CENT, REAR and SUB.W to set the
speaker size that you are going to use it. LUMINANCE will
produce suitable signal output to match the size and number
of speakers in your system.
3. Press SPEAKER SET button again to disable this function
when you finished your speaker mode setting.
•
LARGE (RED indicator):
Suitable setting for speakers that can comfortably
reproduce frequencies below 120Hz
•
SMALL (GREEN indicator):
Suitable setting for speakers that cannot comfortably
reproduce frequencies below 120Hz
•
OFF (OFF indicator):
Set to OFF when no speaker is connected
FRONT: LARGE > SMALL cyclic
Set the FRONT L and R speakers size.
CENT: LARGE -->> SMALL -->> OFF cyclic
Set the CENT speaker LARGE or SMALL or OFF.
REAR: LARGE -->> SMALL -->> OFF cyclic
Set the REAR L and R speakers LARGE or SMALL or
OFF.
SUBWOOFER: ON > OFF cyclic
Set the SUBWOOFER speaker ON or OFF.
F. CHANNEL and LEVEL +, -
Press the CHANNEL button sequentially to select either the
Front Left, Center, Front Right, Rear Right, Rear Left or
subwoofer channel to adjust that channel's output level. Press
LEVEL + or - to adjust each channel output level by 1dB/steps
across the adjustable range of -10dB to +10dB. The level you set
will be indicated in the display window.
NOTE: The LUMINANCE will memorize the CHANNEL LEVEL, the
SPEAKER MODE, Rear and Cent Delay Time and Surround Mode that you
have set for different input source.