2 registration 3. Owners record setup 4. Unit connections 6. Unit care technology 7. Designer’s note 9. Specifications.
3 the model and serial numbers are located on the rear of the unit. Record these numbers in the spaces provided below. Refer to them when calling upon your dealer regarding this product. Model no. _______________________________ serial no. _______________________________ date of purchase: __________...
4 to properly install the ultra monobloc in your audio system, follow these brief steps. 1. Location to provide for adequate ventilation you should allow at least a couple of inches on each side of the amplifier. Because of its large power supply, the amplifier produces a local magnetic field that m...
5 3. Input connections signal input from your preamplifier is made through one gold plated rca (unbalanced) or one xlr (balanced) type connector. Do not use both rca and xlr connectors at the same time as they will load each other improperly. 4. Output connections signal output to your speaker is ma...
6 if you wish to clean your ultra monobloc, use diluted ammonia based window cleaner. Do not use any abrasive cleaners or chemical solvents. Take care not to damage the aluminum faceplate, since aluminum is a medium hardness metal and can be scratched by the careless use of tools during the installa...
7 the legacy ultra monobloc is the most exquisite amplifier we have built. A balanced interconnection is provided to take advantage of the greater noise rejection it provides. Differential voltage gain throughout provides exceptional rejection of external noise and contributes to the inherent dc sta...
8 the current stage is capable of producing peak currents in excess of 90 amperes. This offers a degree of linearity and speed which is not matched by other designs when producing only a fraction of this current. This is achieved by the implementation of several distinct circuit features. The bias s...
9 bandwidth: cd to -3db @ 100 khz distortion: gain: 26db power supply: 1700va toroidal transformer and eight 10,000 µf 100 volt capacitors noise: more than 100 db referenced to rated output. Input impedance: 50 k ohms unbalanced output impedance: 0.08 ohms from 20hz to 20 khz slew rate: 50 volts/mic...
10 © 2003 legacy audio 150 locust street. Macungie, pa 18062 phone: 610 965 0494 fax: 610 965 4915.
