Leggett & Platt E-95MR Operation Manual - page 6
E-95MR Remote Control Operation Guide 99300791-d
6
e-95MR ReMote contRoL pRogRaMMing (1 remote control - 1 base)
FLAT
BUTTON
HEAD
MASSAGE
ON/OFF
BUTTON
TRANSMISSION
INDICATOR LIGHT
FIGURE 3
Program One Remote to Operate One Base - your adjustable
base will be equipped with one of the following: (A) a DC motor
with a power down box, (B) an AC J box, (C) a DC motor without
a power down box (
FIGURE 2).
step 1
(A) DC motor with a power down box: press
the learn button on the power down box for 1
second.
(B or C) AC Jbox or DC motor without power
down box: unplug the adjustable base electrical
power cord. Wait 30 seconds, then plug the
cord back into the power source.
step 2
On the remote control, simultaneously press
and hold the flat and head massage on/off
buttons (FIGURE 3). The transmission indicator
light will flash slowly and then flash rapidly to
indicate programming mode. Continue to hold
for 5 seconds and then release the buttons.
One remote control is now programmed to
operate one base.
FIGURE 2: Power down box, AC J box and DC motor.
LEARN
BUTTON
POWER
DOWN BOX
AC J BOX
POWER DOWN
BOX (NOT
MOUNTED TO
BASE FRAME)
AC J BOX
(MOUNTED
TO BOTTOM
SIDE OF BASE
FRAME)
LEARN
BUTTON
DC MOTOR-NO
POWER DOWN
BOX
DC MOTOR
(MOUNTED TO
BOTTOM SIDE OF
BASE FRAME)
a
b
c