LOBSTER Elite Owner's Manual - page 8
ELITE GRANDSLAM V OPERATING INSTRUCTIONS CONTINUED
Editing An Existing Program
Once you have created a program you may want to adjust or completely redesign
any aspects of the program.
1. If you are not already in the program function, press the Program button
to display the overall Program screen.
2. First use the
/
settings buttons to select the
program you wish to adjust.
3. Next use the menu buttons
/
to highlight
SHOT then adjust the number to reflect which shot
in the sequence you wish to adjust (1st, 2nd, 5th…)
4. Highlight edit and press the
button to change to a yes. This will take you
to the Select Location Screen.
5. The current location of this shot is now displayed in
the upper right corner. If you are satisfied with the
location, press the same number to select it again
and you will advance to the shot parameters screen
which will display your current settings.
6. If you chose another location, the defaults will reset.
7. You can remove the shot from the drill by pressing
button. This will return
you to the overall program screen and the drill will run with one less shot.
Programming Tips
• When you have filled up the 6th shot in a program, selecting next will
automatically take you to the overall program screen.
• You may program drills to have any where from 1 to 6 shots just return to the
overall program screen when you have finished the desired program.
• Certain combinations of speed and spin will not stay within the court. If a setting
will not produce a viable shot the machine will blink to tell you that the shot is
not possible.
• The serving wheels can speed up faster than they can slow down, so fast shots
followed by slow shots will produce shots out the back of the court. If you wish to
use faster feed rates, keep your changes in speed and spin incremental.
PROGRAM
F
K
elite grandslam V
ELITE GRANDSLAM V CONTROL PANEL
A.
Power Button – Push and hold the POWER button to turn the machine on.
Battery level is shown at startup. Both the horizontal and vertical motors will
perform functional checks to calibrate the machine when it is turned on or off.
B.
Remote – Push this button to turn on/off the remote control receiver.
C.
Menu Buttons – Used to scroll through the menu options to be selected and
adjusted. A cursor on the LCD will highlight the current selection.
D.
Settings – Used to adjust a highlighted option on LCD screen.
E.
Play – Press to play and pause the machine.
F.
Presets – Press button multiple times to cycle through the preset modes.
Two-line, Sweep oscillation, Depth oscillation, Fully Random and
pre-programmed Drills.
G.
Program – Press to create customized drills.
H.
1-6 Numbered Buttons – Used to select desired position for
ball to land in program mode.
(More detailed information can be found in the program section.)
I.
Manual – Machine will continuously throw a certain shot to a specific location.
J.
Test – Used to align your machine for proper ball placement on the court.
K. Charger Connector – Used to charge your battery.
L. Main Power Switch – Once you unpack, locate the switch on the bottom rear of the
machine and turn the main power on, to the up position, to allow power to the
control board. If you plan to not use your machine for one month or longer, Lobster
recommends that you turn this switch off.
PROGRAM
PRESETS
A
B
C
D
H
F
E
I
L
K
G
J
P#1 SHOT#2 LOC 4
Press a location
To prgrm shot, or
Press – to erase
PROGRAM # : 1
LOCS 3 4 5 1 6 3
SHOT: 2 EDIT : NO
PUSH PLAY TO RUN
OVERALL PROGRAM SCREEN
SHOT LOCATION SCREEN