1. DL manuals
  2. Lochinvar
  3. Water Heater
  4. Lock Temp SJS060
  5. Installation & Operation Manual

Lochinvar Lock Temp SJS060 Installation & Operation Manual

Summary of Lock Temp SJS060

  • Page 1

    Installation & operation manual models: 60 - 119 the information contained in this manual is intended for use by qualified professional installers, or service technicians. Consult your local expert for proper installation or service procedures.  warning save this manual for future reference. Sjs-i-...

  • Page 2: Hazard Definitions

    2 hazard definitions the following defined terms are used throughout this manual to bring attention to the presence of hazards of various risk levels or to important information concerning the life of the product.  danger  warning  caution caution notice danger indicates an imminently hazardous s...

  • Page 3: General Information

    3 1 general information table 1a details the relationship of water temperature and time with regard to scald injury and may be used as a guide in determining the safest water temperature for your applications. Approximate time / temperature relationships in scalds 120°f more than 5 minutes 125°f 1 1...

  • Page 4: General Information

    4  warning areas of potential danger: 1. All water lines, joints, and valves. 2. If the unit has been in operation, allow the water in the heater and all components and surfaces (tank surface, water piping, etc.,) to cool before starting any maintenance procedures. 3. Assure that all power to assoc...

  • Page 5: Installation

    5 transporting and unpacking the unit each jacketed lochinvar sjs storage tank is cartoned as necessary at the factory. The carton is designed to provide protection for the unit during transportation, and to provide a safe means by which to lift and move the unit with a fork lift or hand truck. Exam...

  • Page 6: Installation

    6 hot water outlet the next step in the installation process is to connect the hot water system piping to the hot water outlet port. The hot water supply tapping is located on top of the tank. A manual shutoff valve should be installed downstream on the hot water outlet line as an isolation device i...

  • Page 7: Installation

    7  warning do not install a manual shut off valve between the relief valve and the discharge. Doing so could cause serious injury or death if the relief valve released and the manual valve was closed. This would cause excessive buildup of pressure in the storage tank which could result in an explos...

  • Page 8: Operation

    8 after all installation procedures have been completed, and all water piping to the energy source and power connections have been double checked, the unit is ready for operation. The following startup procedure focuses on the storage tank. Check the installation and operation manual of the hot wate...

  • Page 9: Inspection

    9 the following table summarizes the recommended time intervals for inspections of the tank, components, water piping and power connections. Recommended inspections to be inspected time interval per manufacturer specs weekly monthly quarterly annually circulating pump gauges - pressure & temperature...

  • Page 10: Maintenance

    10 5 maintenance a new tank installation should have a regular inspection program set up. The first inspection should be within the first three months of operation. Once the tendency to accumulate sediment has been established, the inspection program can be modified to suit the water conditions. Typ...

  • Page 11: Notes

    11 notes installation and operation manual ®.

  • Page 12

    Revision notes: revision a (eco #c11841) initial release. Revision b (eco c11908) reflects the update of chart information in fig. 1-1 on page 3 for sjs080. Revision c (eco #c12382) reflects the addition of the csa low lead content logo. Revision d (eco c15671) reflects the addition of the “locating...