Golf and turf series gt-126 and gt-122 operator’s manual 307 highway 52e, opp, alabama, 36467, (334) 493-1300 locke turf.
Congratulations you have invested in the best implement of its type on the market today. The care you give your locke turf implement will greatly determine your satisfaction with its performance and its service life. We urge a careful study of this manual to provide you with a thorough understanding...
Section introduction …………………………....2 warranty ………………………………...3 safety important safety information …………..4 training …………………………………..4 preparation ……………………………....4 operation ………………………………...4 maintenance and storage ……………...4 operation starting the engine ……………………...6 raising and lowering of cutter uni...
Introduction more than merely devices created for mowing grass, the excellence of design, construction and op- eration of locke power mowers is unparalleled. First introduced in 1928, tested and proven, locke power mowers may be considered, in terms of today’s technology, the ultimate response to th...
Locke mower 2 year limited warranty warranty period and coverage a. Locke turf, inc. Warrants to the original purchaser, and to subsequent owners, that the registered locke mower will be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the orig...
Important safety information this safety alert symbol means: attention! Become alert! Your safety is involved! The safety alert symbol identifies important safety mes- sages in manuals and on equipment safety signs. To avoid possible injury or death, follow the equipment and manual’s safety instruct...
The space between the bottom of the bed knife (a) is slightly greater than that of the front edge (b) by 2 - 3 degrees. See diagram above. Height of cut adjustments the gt series is engineered and designed to offer the most accurate adjustments to produce pristine cutting. An accu-gauge is recommend...
Starting the engine check to see that the oil in the crankcase is at the proper level and there is fuel in the tank. Make sure that the tractor clutch lever, on the right handlebar, and the reel clutch lever, on the left handlebar, are released before attempting to start the engine. Set the engine k...
Lubrication there are 4 pressure lubrication points on the mower. All are zerk type grease fittings. Use a quality light grease at these points. The bronze clutch collars each have a grease fitting. These are located at the front of the tractor on the left and right sides underneath the main guard. ...
Reel bedknife whenever the bedknife is replaced it is essential that the reel and blade be ground or lapped to alignment. Reel to bedknife adjustment the cutting reel is mounted on sealed ball bearings. These bearings are carried in brackets hinged to the reel side plates. The hinged brackets have s...
Resharpening reels for maximum performance and to achieve the finest cut, reels should be reground with a relief. For best results, the “land” area should be no wider than 1/64” to begin the season. (see figure below) modern reel grinders are capable of pro- ducing a relief, finishing off the cylind...
Locke turf 307 highway 52e, opp, alabama, 36467, (334) 493-1300
