LockState LS-PTC300 Hardware Installation

Page of 3

Download

Bookmark us

LS-PTC300 CAMERA MANUAL

Hardware Installation

1) Insert the power cable and the Wi-Fi antenna into their respective ports on the camera. Tighten the

Wi-Fi antenna until it is secure and not loose.

2) Insert one end of the Ethernet cable into the camera’s Ethernet port and insert the other end into an

open port on your router.

Please note: Initial installation requires an Ethernet cable to be used to configure the camera to your

wireless network. After the camera is configured, the Ethernet cable can be removed from the camera to

only use the wireless connection (power cycle required). If the wireless network’s credentials change then

the device will need to be reconfigured using the Ethernet cable.

3) Plug the AC adaptor into a compatible wall outlet for power.

4) The “audio output” port is for external speakers and is optional.

Camera Provisioning – UPnP method

If Universal Plug and Play is enabled on the connected router, the web portal can setup the camera’s

wireless settings as well as the necessary IP information.

Please note: If this method does not work and you receive a message stating “Camera Information

Received, But Cannot Configure Camera”, then proceed to the “Camera Provisioning – Port Forwarding

method”.

1) Navigate to https://connect.devicewebmanager.com and sign in to the administrator account. If no

account has been created, please create one via the “Sign Up” link on the login page.

2) Navigate to the camera tab on the dashboard and select “New Camera”.

3) Complete the name, MAC address (found on the bottom of the camera), model, and property fields.

Once completed, select “Create Camera”.

4) Follow the on screen prompts to complete camera installation and setup.

5) If a message comes up stating “Camera Information Received, But Cannot Configure Camera” then

proceed to the Non-UPnP method below.

Page 1
Ls-ptc300 camera manual hardware installation 1) insert the power cable and the wi-fi antenna into their respective ports on the camera. Tighten the wi-fi antenna until it is secure and not loose. 2) insert one end of the ethernet cable into the camera’s ethernet port and insert the other end into a...
Page 2
Camera provisioning – port forwarding method (non-upnp) if universal plug and play is disabled or not an option on the connected router, then port forwarding will need to be setup on the router to allow the camera to connect outside of the local network. 1) forward the camera’s port in the router. T...
Page 3
C. Changing camera port to not interfere with other device’s forwarded ports. 1. Sign into the camera’s web setup page. The sign in page can be access by entering the camera’s internal/private ip address followed by a colon and then the port number. For example 192.168.1.25:8080 i. The default usern...