LockState ResortLock LS-RL2000 Installation & User Manual

Front Handle & Key Installation

1. Ensure that the key override slot 

is in the horrizontal position.

2. Slide the key cylinder into the 

back of the  handle.

3. Insert the key into the key  cylin-

der from the front of the  handle 

and turn 90  clockwise.

5. Press in both catch pins and snap 

handle over pins.

4. Slide the handle onto the brass 

drive shaft until it hits the catch 

pins.

6. Turn key back to the left  and 

remove the key from the  key 

cylinder.

Step 3

Screw in and tighten both fastener 

extensions (D). Attach and tighten 

optional upper fastener post (E) if 

needed.  Upper post is recommended 

but not required.

Step 4

Place the front of the lock onto the door 

with the rubber gasket (F) between the 

door and the lock housing. Feed the 

power cable (G) through the door hole.

Step 5

Attach the battery plate on the inside 

door with the rubber gasket between the 

door and battery plate. Feed the power 

plug through the small rectangular hole 

on the plate. Secure the battery plate to 

front lock fastener posts with 2 screws.

Step 6

Install 4 AA batteries and plug in the 

power cable (G). Secure the back lock 

housing onto the battery plate with the 

upper and lower screws. Press both 

catch pins in and snap the rear handle 

onto drive  shaft.

G

Major Lock Parts List

Installation Instructions

Step 1

Insert the latch into the latch 

hole.  Secure the latch with two 

screws.

Step 2

Insert the square spindle (A) into the center hub 

(B).  Then secure the spindle by inserting the 

position pin (C) through the hole in the hub & 

spindle.  Bend the ends of the pin around the hub 

to secure.

Installation & User 

Manual

For use with ResortLock® RL2000 and LockState® LS-1250

®