Templ a te 45 40 35 1-3 /4 " 1-9 /1 6" 1-3 /8 " fit her e on door edge for backse t 70mm (2-3/4”) for backse t 60mm (2-3/8”) 51 2" mar k 1" (25.4mm) hole at center of door edge. Ø Ø54mm (2-1/8") electronic deadb lt lock o 1 2 3 4 5 6 7 8 9 0 user manual ® lockstate 1325 s. Colorado blvd. Suite 400 d...
1 2 wi-fi electronic deadbolt installation instructions 2-3/4 " (70mm) the backset is the distance between the center of cross bore and edge bore of the door. Adjustable latch fits both backset of 2-3/8” (60mm) and 2-3/4” (70mm). Please follow the steps shown below for backset adjustment. A. Insert ...
3 4 5. Install keypad assembly a. Ensure the latch bolt must be retracted. B. Please refer to the diagram below for cylinder installation. Place deadbolt against keypad with tailpiece in horizontal position inserted through hub of the latch. C. Pass the ic wire under the latch to the interior side o...
5 programming button/enter button number buttons cylinder washer battery lid battery holder the programming/enter button is utilized for unlocking the door after entering user codes, clearing errors and programming the lock. It's also a lock button. Enter user codes (4-10 digits in length) and progr...
7 8 keypad programming functions auto-detect lock handing (deadbolt lock only) enter pc 140 note : if you have a lever lock you do not need to run this operation. For deadbolt locks, please run the door-handing identifying before doing anything else on your lock. Put your lock in the locked position...
9 10 detailed lock functionality four aa（1.5v）alkaline batteries. 1.Battery 1. The batteries should be changed immediately once you see the led flashes in red and hear 6 beeps when press the lockstate button. 2. All settings are retained in the memory and will not be affected even if the battery is ...
12 simple troubleshooting 11 the door-handing identifying process is not yet complete. Please execute the door-handing identifying process as soon as the installation of the lockset is completed. It could be a problem caused by incorrect battery insertion or the improper connection ofthe cable. Chec...
