LockUP Employee Lock User Manual - Step 6

6

Follow the Programming section of this 

manual on pages 12-15.

Step 6

Step 5

NOTE:

 If during operation of the lock, the lock  

emits 10 rapid beeps and 10 flashes of the LED 

light, it is an indicator that the bolt/latch of the lock 

is binding with the door strike plate and/or frame. If 

this occurs, the door and/or strike plate may need 

to be aligned or adjusted. It may also be an indica-

tor that the locking nuts are over tightened on the 

screw posts.

Test the operation several times (as indicated 

below) while the door is open. Close the door and 

test the unit again. Make sure there is no binding 

between the bolt/latch and the door strike plate and/

or frame. Adjust alignment if necessary.

To lock and unlock press: 

= 

then 

`

NOTE:

 Do not touch the rear unit connector pins  

(male connector) against any metal or other conductive  

surfaces. This may short the batteries and cause  

damage to the lock.

NOTE:

  An  audible  triple  beep  and  three  flashes  of 

the  LED  light  indicate  that  the  lock  was  connected  

properly. If you do not hear these beeps, separate the 

units, press the “C” button on the keypad and reconnect 

the front and rear units on the door.

Slide  the  front  unit  (A)  and  rear  unit  (B)  together  

making sure that the pins of the rear unit align with the 

front unit (A) connector.

Step 3

Place the locking nuts (C) over the mounting screws 

and tighten to secure the lock to the door.

Step 4