Summary of Talisman
Page 2: Logaire Talisman Woodfires
The installation and operating instructions in this manual apply to logaire talisman woodfires note: while all models have been tested to show compliance with the emission limits of as/nzs.4013:1999, only some models may be installed in districts having lower allowable emission limits. Please check ...
Page 3: Introduction
Introduction in the interests of your safety, most building regulatory authorities in australia and new zealand require any woodfire installation to comply with installation standard as/nzs 2918. They may also have local requirements in addition to those in the standard. Check with your local buildi...
Page 4
Unpacking do not remove the polystyrene packers above the top baffle of the firebox at this stage. Do not discard the top baffle. Remove and discard the four bolts holding the woodfire to the shipping pallet. Remove the woodfire from the pallet, lifting only from the lower edge of each side. Do not ...
Page 5
Floor protector (hearth) requirements unless your woodfire will be standing on an un-covered fireproof floor (containing no combustible material) extending at least 500mm from the appliance, it will be necessary to provide a floor protector (hearth). See page 5 for construction details. Where the mi...
Page 6
Minimum dimensions — mm see below for construction. X y talisman with shelf 1090 450 your measurement ‘e’ must be added to ‘x’ and ‘y’ to find the appropriate minimum overall floor protector dimensions. See page 3 for minimum values of ‘e’. † increase ‘y’ by 120mm if the floor protector top is not a...
Page 7
Installing the flue you must use a flue system which complies with the current installation standard as/nzs 2918. Full instructions are supplied with the flue kit, and these must be followed closely, including the minimum flue exit height from the top of the floor protector and the minimum exit heig...
Page 8: Operating Instructions
Operating instructions basic information door handle the door is opened by pulling forward on the lower part of the handle. Hold the handle in this forward position when shutting the door, finally pushing it back to vertical to lock the door. Heat output control this control has a sliding action. Pu...
Page 9
Move the heat output control away from the maximum position only after the fire is well established. A new woodfire should not be run at higher than half setting beyond the first 30 minutes until it has been used for a total of 8 hours. Once fully ‘run in’, we recommend running at full heat for up t...
Page 10
Safety • always keep children well away from the woodfire when it is alight. • the appliance is not intended for use by young children or infirm persons without supervision. • supervise young children to ensure they do not play with the appliance. • if the supply cord is damaged it must be replaced ...
Page 11
The tube will have one removable angle pin to prevent it from moving endways and falling out. One end of the tube will have a welded-on locating pin. To remove the tube, simply withdraw the angle pin from the tube, move it sideways until one end can be swung down from its locating hole in the firebo...
Page 12
Fan maintenance (if fitted) only the manufacturer, its service agent or a similarly qualified person should remove the fan box to carry out fan installation, servicing and maintenance. The fan should need little attention other than occasionally (perhaps once a year) removing it to clean dust and li...