Logan F500-2 Instruction Sheet - Operating Instructions

Operating Instructions

Blade install: (Fig. 1)

1. Determine right hand or left hand usage.

2. Remove nut and three (3) blades. 

3. Separate and install one blade, sharp edge down. 

4. Slide cover to “safe” when not using and “blade” when ready to use. 

Apply dust cover:

1. Using double sided tape, ATG tape or glue, apply continuous line around 

back of frame about 1/8” from edge. (Fig. 2)

2. Cut a piece of Kraft paper (30, 40, or 50 lb available at craft stores) that 

is larger than overall outside of frame by a minimum of 1”.

3. Lay paper flat onto table and drop the frame straight down onto the 

paper with taped side down and artwork side facing up. (Fig. 3)

4. Using water in a spray bottle, completely dampen Kraft paper evenly. As 

water dries, the paper will shrink tight. (Fig. 4) NOTE: Use a hairdryer to 

decrease drying time.

5. Crease paper along the edges of frames. (Fig. 5)

6. Using trimmer, start beyond edge of a corner, hold on slight angle up 

against frame edge. Draw trimmer along edge to trim. (Fig. 6)

7. Repeat for other three sides. 

Model F60 

DUST COVER TRIMMER

L2222  01/15

Fig. 4

Fig. 5

Fig. 1

Fig. 2

Fig. 3

PICTURE FRAMING

Instruction Sheet

Fig. 6

Logan Graphic Products Inc. 1100 Brown Street, Wauconda, IL 60084 1-847-526-5515 1-800-331-6232

www.logangraphic.com

Sharp Edge

Left  hand  

usage

mount 

side

Right  hand    

usage

mount side

Artwork Side Up