Logic CDU650 Instruction Manual - Installation
1
53mm
182mm
3
2
182mm
53mm
1
2
1
3
4
Release screw and
bracket
Bend these
claws, if necessary
INSTALLATION
PRECAUTIONS
• Choose the mounting location carefully so that the unit will not interfere with normal driving functions.
• Avoid installing the unit where it may be subject to high temperatures, such as from direct sunlight or
hot air from the heater, or where it may be subject to dust, dirt or excessive vibration.
• Use only the supplied mounting hardware for a safe and secure installation.
• Be sure to remove the front panel before installing the unit.
Mounting angle adjustment
Adjust the mounting angle to less than 20°.
MOUNTING EXAMPLE – Installation in the dashboard
Note: Keep the release key in the safe place as you may need it in future to remove the unit from the car.
Detaching and attaching the front panel
The front panel of this unit can be detached to prevent theft.
FOLDING DOWN AND DETACHING/ATTACHING THE FRONT PANEL
Before detaching the front panel, be sure to press the
button (1) OFF first.
Then press the
button and detach the panel by pulling it towards you as illustrated.
Notes:
• Do not press the front panel hard against the unit when attaching it. It can be easily attached by pressing
it lightly against the unit.
• When you carry the front panel with you, put it in the supplied front panel case.
• Do not press hard or give excessive pressure to the display window of the front panel when attaching
it to the unit.
CLEANING THE CONNECTOR
The unit may not function properly if the connectors be-
tween the unit and the front panel are contaminated with
dirt. In order to prevent this from happening, detach the
front panel by pressing
the
button and clean the con-
nectors from time to time.
Clean the connectors with a cotton swab and contact
cleaner as illustrated. Clean each pin carefully and make
sure not to damage the connecting points.
Cotton Swab
Rear of
front panel
Main unit
2
1