Model: cr3000 series compact cash drawers compact, with small footprint user manual.
Notice the manufacturer of the pos cash drawer makes no representations or warranties, either expressed or implied, by or with respect to anything in this manual, and shall not be liable for any implied warranties of fitness for a particular purpose or for any indirect, special or consequential dama...
Table of contents features ................................................................................. 1 carton contents ................................................................ 2 interface description ...................................................... 2 installation .................
Features • low cost • small foot-print with efficient use of internal space • drawer opens from any pos printer drive circuit • bill and coin compartments • three-position lock for maximum cash security • high security - no screws on the outside of the case • check slot for non-cash or large-bill tr...
Carton contents cr3000 1. Cash drawer, pre-assembled 2. Printer interface cable 3. Two keys 4. User’s manual interface description model cr3000 - printer driven interface: connect the drawer to the pos printer as shown in figure 1. Whenever the pos application software sends a drawer open command to...
Installation your cash drawer has been pre-assembled to make the installation as simple as possible. Model cr3000 1. Remove the cash drawer from its shipping container. 2. Remove the keys and interface cable from its plastic bag. 3. Connect the interface cable to the printer. 4. Connect the other en...
Functional test the following test sequence will verify that your cash drawer is working properly. Before you start this procedure, you must install the cash drawer correctly as outlined in the installation section note: the actual key entries are enclosed within quotation marks (“ “). Do not type t...
Model cr3001 with non-dedicated interface 1. From the c prompt type “mode com1 96,n,8,2” and press enter. 2. Type “type con>com1” and press enter. 3. Type “^g” and press enter. The cash drawer will open if the security code is 07 hex as set by the manufacturer. Note:if another security code has been...
Key lock operation all cash drawers have a three position key lock for maximum security. The fully counter clockwise lock position offers maximum security. The cash drawer can not be opened by computer or an individual when the lock is in the full counter clockwise position. With the lock in the cen...
Specifications mechanical: weight 14.3 lb. (6.5 kg) height 3.3 in. (8.5 cm) width 15.7 in. (40 cm) depth 16.1 in. (41 cm) electrical: input to solenoid (cr3000, cr3001) pulse amplitude 12vdc to 24vdc pulse width 100 milliseconds to 200 milliseconds pulse duty cycle 10% maximum peak current 1 ampere ...
Connector pin out figure 5 will show the connector arrangement for the cr3001 cash drawer. The following charts will show the function of each pin. P1 (db25 m) - parallel input from computer p2 (db25f) - parallel output to printer pin # function pin # function 1 -strobe 13 select 2 data 0 14 -auto f...
P3(db25m) - serial input from computer p4(db9f) - pass thru serial output p5(db9m) - pass-thru serial output pin # function 1 no connection 2 receive data from computer 3 transmit data to computer 4 rts, request to send; from computer (tied to pin 5 internally) 5 cts, clear to send; to computer (tie...
P6 (db9m) - serial input from computer pin # function 1 dcd, tied to pins 4 & 6 2 transmit data to computer 3 receive data from computer 4 dtr, tied to pins 1 & 6 5 ground 6 dsr, tied to pins 1 & 4 7 rts, tied to pin 8 8 cts, tied to pin 7 9 no connection controller board jumpers ( located inside th...
11.
12.
13.
