Logic LBMULB12 Instruction & Installation Manual - Oven
13
Oven
• The oven should be cleaned after every use.
• The oven chamber should only be washed with hot water and small amount of washing-up liquid.
• After cleaning the oven chamber wipe it down and leave the oven door open to allow the interior to
completely dry.
• Wait for the oven completely dry before restoring power.
Troubleshooting
In the event of unexpected operation, you should:
• Switch off the oven and if possible, disconnect it from the mains supply. Make sure all control knobs are set to
the “0” position.
• Call the customer support centre.
• Some minor faults can be fixed by referring to the instructions given in the table below. Before calling the
customer support centre, check the following points.
Problem
Reason
Action
The appliance does not work.
• Break in power supply
• Manual mode is not
selected
• Check the household fuse box, if there is
a blown fuse replace it with a new one.
• Select manual mode
The oven lighting does not work. The bulb is loose or
damaged
Tighten up or replace the bulb. (See
replacement of the oven lamp)
Cleaning and Maintenance
By ensuring proper cleaning and maintenance of your cooker you can have a significant influence on the
continuing fault-free operation of your appliance.
Before you start cleaning, the cooker must be switched off and isolated from the mains supply and you should
ensure that all controls are set to the “0” position. Do not start cleaning until the cooker has completely cooled.
• It is advisable to use a solution of hot water with a little washing-up liquid or cleaning products suitable for
cleaning stainless steel sinks.
• Steam cleaners must never be used.
• Do not use abrasive pads to clean any part of the oven. If using commercially available oven cleaners ensure
they are suitable for the type of oven and follow the manufacturer’s instructions.
• When cleaning the fan guard, the oven must be switched off.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they
can scratch the surface, which may result in the glass shattering.
Take care when handling parts with glass, knocks, and chips; heavy handling and dropping could
cause the glass to shatter.
LBMULB_X12_IB_120601_Annie.indd 13
12年6月1日 下午12:00