M-Audio KEY RIG User Manual - page 6
8
Preset Select Wheel 1: this rotary knob chooses a piano preset from the following list—
01 Natural Grand
02 Bright Grand
03 Soft Grand
04 Hard Grand
05 Concert Grand
06 Upright
07 Honky Tonk
08 Electric Piano 1
09 Electric Piano 2
10 Wurli
11 FM Piano
12 None
Velocity: adjusts the velocity (dynamic) response for preset 1. A setting of full (to the right) sets the largest dynamic range between hard and
soft played notes. A setting of zero (to the left) velocity has no effect on dynamics.
Tone: turning the knob to the left filters or reduces the brightness of the preset.
Mix: sets the volume balance between preset 1 and 2.
Split: sets the note at which the keyboard splits. Preset 1 always plays below the split point and preset 2 always plays above (including the
selected note). Possible split notes are: C2, F#2, C3, F#3, C4, F#4, C5.
Detune: turning to the right adjusts the tuning of preset 1 negatively and preset 2 positively.
Preset Select Wheel 2: preset 2 contains the same piano presets as preset 1, but has three additional pads—
01 Natural Grand
02 Bright Grand
03 Soft Grand
04 Hard Grand
05 Concert Grand
06 Upright
07 Honky Tonk
08 Electric Piano 1
09 Electric Piano 2
10 Wurli
11 FM Piano
12 Straight Pad
13 Sweep Pad
14 Long Reso Pad
15 None
Octave: transposes preset 2 up or down by one or two octaves.
Tone: turning the knob to the left filters or reduces the brightness of preset 2.
Serial/Parallel
• Serial: Both presets input to FX 1, the output of FX 1 is then input to FX 2.
• Parallel: Preset 1 is input to FX 1. Preset 2 is input to FX 2.
FX Preset Drop-Down Menu: clicking anywhere inside the white FX name field produces a drop-down FX presets list, featuring the same
effects presets available in the master “FX Type” menu.
Mix: sets the wet/dry balance of the effects.
Effects Edit Controls: the two white fields to the right of the FX mix controls display the effect parameters that can be edited, which vary in
name depending on the selected effect preset.