M-Audio LX4-2.1 User Manual

Manual is about: Studiophile Series

Summary of LX4-2.1

  • Page 1

    Users manual introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 what’s in the box? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 studiophile lx4-2.1 features . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Page 2: Introduction

    Introduction thank you for choosing the lx4-2.1 studiophile series 2.1 / 5.1 studio nearfield monitor speakers. M-audio is well known for digital audio interface technology, digital converters, audio preamps and mixers. Now, after extensive research and development, the studiophile lx4-2.1 is born t...

  • Page 3: Studiophile Lx4-2.1 Features

    Studiophile lx4-2.1 features 1.Woofer - the woofer unit is 4 inches in diameter with a magnetically shielded mineral-filled polypropylene cone, high-temperature voice coil and damped closed cell foam surround. It is designed to deliver balanced mid- and low- frequency response. Polypropylene is used...

  • Page 4

    Front and rear panel features rear panel 1. Trs inputs: these jacks accept 1/4” connections with either balanced or unbalanced wiring. For balanced wiring, a three-conductor trs plug is necessary.The input wiring of a trs connector should be as follows: trs tip - signal positive (+) trs ring - signa...

  • Page 5

    2. Sub volume: use the sub volume to set the subwoofer output sound pressure level relative to other output channels as required. Once the subwoofer to satellite balance is achieved, use the master volume to control overall listening levels. 3. Power / protect. Led: when the power switch is switched...

  • Page 6: Installation

    Installation for optimal performance of the lx4-2.1, please read the following thoroughly and carefully prior to installation. Precautions handling: please do not touch the speaker cones.The lx4-2.1 set is packaged in the box tightly, so your attention is required when taking the monitors out of the...

  • Page 7

    Speaker wire connections use speaker wires included in lx5-2.1 package to connect the left and right channel speaker outputs to the left and right speakers. Connecting to preamp, computer or game console outputs before connecting, make sure the output device’s power has been turned off. Plug the trs...

  • Page 8: Placing The Lx4-2.1

    Placing the lx4-2.1 placing the speakers is one of the most important procedures.To monitor with the lx4s performing to their maximum capability, an appropriate listening environment and correct placement are required. Please refer to the following for correct lx4-2.1 placement. 1. As a subwoofer is...

  • Page 9

    4. Place the lx4’s left and right units vertically with the woofer on the bottom. Placing the lx4 monitors horizontally is not recommended. Note: do not place any obstacles that may block the flow of air in front or between the lx4s monitors. Also remove reflective materials such as glass, mirrors o...

  • Page 10

    Studiophile lx4 2.1 warranty terms m-audio warrants that this product is free of defects in materials and workmanship under normal use for a period of one (1) year from purchase date, so long as the product is: owned by the original purchaser; the original purchaser has proof of purchase from an aut...

  • Page 11

    Appendix a - technical specifications type: 3-way studio reference with subwoofer – 2.1 system, expandable to 5.1 subwoofer driver: 8 inch diameter, specially-developed curved-profile pulp cone, high-temperature voice coil and damped closed cell foam surround - designed for sub-frequency pressure le...

  • Page 12: Appendix B - Block Diagram

    Appendix b - block diagram 12.