M-Audio Mixim 10 Manual

Summary of Mixim 10

  • Page 1

    Contents introduction ................................................................. 2 front & rear panels - fig. 1 ....................... 4 overview .......................................................................... 5 channel controls and inputs ............................................

  • Page 2

    2 introduction this product complies with european ce requirements. Thank you for your purchase of the midiman mixim 10 audio mixer. Midiman may not be well known as a manufacturer of line mixers. However, we have designed and manufactured over 4 different models including minimixer, fineline, micro...

  • Page 3: Live Band, Duos and Trios

    3 nal effects) and more, it will more than meet any of your digital audio input and mixing needs. Live band, duos and trios mixim 10 takes up very little space. With its built-in mic preamps and variety of controls, it can mix all instruments along with microphones and drive a power amplifier. Home ...

  • Page 4

    4 front & rear panels - fig. 1 gain • • • 00 +20 • • • • send • • • 0 +6 • • • • send • • • 0 +6 • • • • send • • • 0 +6 • • • • send • • • 0 +6 • • • • send • • • 0 +6 • • • • send • • • 0 +6 • • • • low • • • -15 +15 • • • • mid • • • -15 +15 • • • • high in 1 mic 1 in 2 mic 2 • • • -15 +15 • • • ...

  • Page 5: Channel Controls and Inputs

    5 overview while reading the following description of how mixim 10 works it may be helpful to refer to the preceding front and rear panels - figure 1, or the block diagram - figure 3 located in the back of this manual. Channel controls and inputs channels 1 to 4: the mixim 10 has 4 mono inputs (1 th...

  • Page 6: Channels 5/6 and 7/8:

    6 channels 5/6 and 7/8: 5/6 and 7/8 are stereo channels. This means that the gain controls on these channels attenuate both of the respective inputs. When you turn the balance controls on these channels all the way to the left you will only get the left input (5 or 7) going to the left main output. ...

  • Page 7: Stereo Return

    7 stereo return mixim 10 has a stereo return. This return is designed to be used with a tip/ring/sleeve jack. The tip goes left, the ring goes right and the sleeve is common (ground) to both channels. The stereo return level is controlled by the mixim 10's "stereo rtn" pot. If you are not using the ...

  • Page 8

    8 typical set-up - fig. 2 stereo left power amplifier left right right left right input output mix effects unit out r & out l send str ret to eqable ins (3 & 4) to unity gain ins (9 & 10) speakers microphones left output right output gain • • • 00 +20 • • • • send • • • 0 +6 • • • • send • • • 0 +6 ...

  • Page 9: Way Down.

    9 setting up (see "typical set-up" diagram) when setting up, you should first decide if you are going to need mic inputs. If you are going to be using mics you need to set the line gain dip switch of the channel you will be using (1 or 2) to high. If you are going to use one of these channels as a m...

  • Page 10: Headphones

    10 the output levels of mixim 10 are controlled by the stereo main level pot. When set to 9 o'clock, mixim 10 has unity gain. This is the best setting for going into a mixing board. If you are going into a power amplifier, this pot will act as a convenient volume control. Headphones a headphone ampl...

  • Page 11

    11 enables you to incorporate stereo effects in your mix. If you need more than one stereo return, use two of the regular channel inputs. This technique also enables you to adjust the placement of the effect in the stereo field by adjusting the pan pots on the chan- nels to which you have routed the...

  • Page 12

    12 limited lifetime warranty midiman warrants that this product is free of defects in materials and workmanship under normal use so long as the product is owned by the original purchaser and that purchaser has registered his/her ownership of the product by sending in the completed warranty card. In ...