M.E.Y. Equipment None Manual

Manual is about: M.E.Y Equipment Mower Manual

Summary of None

  • Page 1

    M. E. Y. Equipment mower manual 200 collier road, bayswater. Western australia 6053 telephone (08) 9370 1110, facsimile (08) 9370 2566 web site: www.Mey.Com.Au email: info@mey.Com.Au introduction the technical data and service recommendations referred to in this maintenance manual relates to m. E. Y...

  • Page 2

    • exercise extreme caution when changing direction on slopes; • do not mow excessively steep slopes; • use extreme caution when reversing or pulling the lawnmower towards you; • stop the cutting cylinder when emptying the catcher & crossing surfaces other than grass; • never operate the lawnmower wi...

  • Page 3

    General recommendations • the mower / motor should not be reclined more than 45° when adjusting the blade setting, servicing the machine or loading it onto trailers or other transport. This is to prevent sump oil entering the combustion chambers. Ideally, the mower handles should be rested on the ca...

  • Page 4

    Operating instructions before you start the mower: 1. Check the engine oil. Ensure that the mower is stationary and on level ground. Remove the grey filler cap at the front of the engine and check the oil level using the dipstick. Low levels will result in serious engine damage and overfilling can r...

  • Page 5

    • turn the fuel tap, situated on the side of the carburettor, to the on position. • move the grey choke lever, situated on the side of the carburettor, to the choke position. ••••check that the cylinder and drive clutch levers are in the disengaged position. • move the on/off switch, situated on the...

  • Page 6

    Front roller cam height adjusters the two cams fitted to the front roller of m.E.Y mowers enable the operator to quickly change the cutting height to suit varied conditions and requirements. See fig 4 loosen one front roller end bolt at a time, with the special spanner provided. By rotating the cam ...

  • Page 7

    Cutting cylinder frequent fine adjustment of the cylinder to the bottom blade will give the best cutting performance and extend the period between sharpening. The design of the cylinder enables the trailling edge to be sharpened while the machine is in operation. It is recommended to reverse the cyl...

  • Page 8

    To remove the front roller turn off the petrol and turn the engine to top dead centre lay back mower on 20 litre drum or catcher. Remove the bolts at each end of the front roller shaft. Repair as found necessary and refit. Note, the two bearings are secured with circlips behind the end seals. Align ...