Fokker dviii 55” copyright© 2006-11 m. K. Bengtson all rights reserved rev 07/11 fokker dviii 55” r/c scale model instructions contact information the fokker dviii was designed by m.K. Bengtson prototype by edi werner manufactured and distributed by: bengtson company e-mail: sales@aerodromerc.Com we...
Fokker dviii 55” page 1 copyright© 2006-11 m. K. Bengtson all rights reserved rev 07/11 fokker dviii 55” thank you for purchasing the fokker dviii model for electric flight. The model a semi scale adaptation of the fokker dviii, this model is designed to be easy to build and exciting to fly. Finishe...
Fokker dviii 55” page 2 copyright© 2006-11 m. K. Bengtson all rights reserved rev 07/11 wing construction detail build center wing section separately and without top spars. Outer panel r2 angle gauge is used to lean rib r2 on outer panel towards wing tip two laminations of 1/16” plywood for wing bra...
Fokker dviii 55” page 3 copyright© 2006-11 m. K. Bengtson all rights reserved rev 07/11 then joined over the plan. This system not only keeps each stage simple, but it also helps to ensure a straight fuselage. Building of the rear of the fuselage begin by building two rear fuselage frames over the p...
Fokker dviii 55” page 4 copyright© 2006-11 m. K. Bengtson all rights reserved rev 07/11 tail surfaces construction detail landing gear the landing gear is made from 3/32”” music wire, bent as shown on the plan. Landing gear construction detail underwing the underwing is built around the axle with a ...
Fokker dviii 55” page 5 copyright© 2006-11 m. K. Bengtson all rights reserved rev 07/11 reinforcing hubs are provided that are to slip over the brass tubing as shown. Next, ca glue the neoprene cording together to from a “tire”. Use thin ca sparingly as the ca bonds very aggressively to the rubber. ...
Fokker dviii 55” page 6 copyright© 2006-11 m. K. Bengtson all rights reserved rev 07/11 hollow out body to make it as light as possible dummy spandau machine guns. Make from 1/8" balsa core sandwich 1/16" balsa on stock area add round spacers, and dowel attach copy of vent pattern shown balancing th...
Fokker dviii 55” page 7 copyright© 2006-11 m. K. Bengtson all rights reserved rev 07/11 “this one is very well-behaved, can be flown very slow, almost stalled and shows no tendency to tip-stall, she's just a bit reactive to wind. When i said that she reminds me very much of my dr.1, these were the c...
