M-system FJR Instruction Manual
FJR
P. 1 / 4
EM-1464 Rev.7
INSTRUCTION MANUAL
MODEL
FJR
RTD TRANSMITTER
(field-programmable)
COMPONENT IDENTIFICATION
■
FRONT PANEL CONFIGURATIONS
INSTALLATION
Pull out the body in pressing the clamps located at the top and
bottom of the unit to separate it from the base socket.
■
DIN RAIL MOUNTING
Set the base socket so that its
DIN rail adapter is at the bot-
tom. Hung the upper hook at
the rear side of base socket on
the DIN rail and push in the
lower. When removing the
socket, push down the DIN
rail adapter utilizing a minus
screwdriver and pull.
■
WALL MOUNTING
Refer to the drawings in the
following page.
DIN Rail
35mm wide
Spring Loaded
DIN Rail Adaptor
BEFORE USE ....
Thank you for choosing M-System. Before use, check the
contents of package you received as outlined below.
If you have any problems or questions with the product,
please contact M-System’s Sales Office or representatives.
■
PACKAGE INCLUDES:
Signal conditioner (body + base socket) ..................... (1)
■
MODEL NO.
Check that model No. described on specification label is
exactly what you ordered.
■
INSTRUCTION MANUAL
This manual describes necessary points of caution when you
use this product, installation and connection, hardware
setting, and basic maintenance procedures.
When you need to change software settings, please refer to
the Operation Manual for Model PU-2
❑
(EM-9255), Section
A.
POINTS OF CAUTION
■
POWER INPUT RATINGS
• Power input ratings are specified by the model number
suffix code. Check the power input voltage for the unit on the
specification label.
85 – 132V AC rating: 85 – 132V, 47 – 66 Hz, approx. 4.5VA
170 – 264V AC rating: 170 – 264V, 47 – 66 Hz, approx. 4.5VA
24V DC rating: 24 V ±10%, approx. 70mA
110V DC rating: 85 – 150V, approx. 20mA
■
REMOVING THE UNIT
• Before you remove the unit from its base socket or mount
it, turn off the power supply and input signal for safety.
■
ENVIRONMENT
• Indoor use
• When heavy dust or metal particles are present in the air,
install the unit inside proper housing with sufficient ventila-
tion.
• Do not install the unit where it is subjected to continuous
vibration. Do not subject the unit to physical impact.
• Environmental temperature must be within -5 to +55°C (23
to 131°F) with relative humidity within 30 to 90% RH in
order to ensure adequate life span and operation.
■
WIRING
• Do not install cables (power supply, input and output) close
to noise sources (relay drive cable, high frequency line, etc.).
• Do not bind the unit's cables together with other cables
where high noise levels are present. Do not install them in
the same duct.
■
AND ....
• The unit is designed to function as soon as power is
supplied, however, a warm up for 10 minutes is required for
satisfying complete performance described in the data sheet.
Body
Base Socket
Specification Label
Connection
Diagram Label
(side)
Modular Jack