Summary of MVW 681
Page 1
Bedienungsanleitung geschirrspüler seite 2 instruction book dishwasher page 23 mvw 681.
Page 2: Contents
Safety instructions 24 disposal 24 economical and ecological dishwashing 24 installation instructions 25 building-in 25 levelling 25 fixing to adjacent units 25 water supply connections 25 water inlet hose with safety valve 25 water outlet hose connection 26 electrical connection 26 description of t...
Page 3: Disposal
It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new own...
Page 4: Installation Instructions
Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person. Remove all packaging before positioning the machine. If possible, position the machine next to a water tap and a drain. Building-in this dishwas...
Page 5
Water outlet hose connection the end of the drain hose can be connected in the following ways: 1. To the sink outlet spigot, securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine. 2. To a stand pipe provided with vent-hole, minimum int...
Page 6: Description of The Appliance
Description of the appliance 27 1. Upper basket stop 2. Water hardness dial 3. Salt container 4. Detergent dispenser 5. Control panel 6. Rating plate 7. Rinse aid dispenser 8. Filters 9. Lower spray arm 10. Upper spray arm 11. Upper basket.
Page 7: The Control Panel
Function buttons: in addition to the selection of the washing programme and the "half load", the following functions can also be set with the help of these buttons: - water softener setting, - deactivation/activation of the rinse aid dispenser, - deactivation/activation of the audible signals. "prog...
Page 8
Audible signals audible signals have been introduced to help indicate which operations the dishwasher is performing: "setting of the water softener" "end of programme" "something not working with the machine" deactivation/activation of the audible signals (the dishwasher must be switched off) factor...
Page 9
Before using your dishwasher for the first time: 1. Ensure that the electrical and water connections comply with the installation instructions. 2. Remove all packaging from inside the appliance. 3. Set the water softener. 4. Pour 1 litre of water inside the salt container and then fill with dishwash...
Page 10
Filling with dishwasher salt only use salt specifically designed for use in dishwashers. All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener. Only fill with salt just before starting one of the complete washing programmes. ...
Page 11
Rinse aid rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting...
Page 12: In Daily Use
● check if it’s necessary to refill with dishwasher salt or rinse aid ● load cutlery and dishes into the dishwasher. ● fill with dishwasher detergent . ● select a wash programme suitable for the cutlery and dishes. ● start the wash programme. Loading cutlery and dishes sponges, household cloths and ...
Page 13
The cutlery basket long bladed knives stored in an upright position are a potential hazard. Long and/or sharp items of cutlery such as carving knives must be positioned horizontally in the upper basket. Take care when loading or unloading sharp items such as knives. Removable knife basket long and/o...
Page 14
Adjusting the height of the upper basket if washing very large plates you can load them in the lower basket after moving the upper basket to the higher position. To move to the higher position proceed as follows: 1. Pull out the basket until it stops. 2. Carefully lift both sides upwards until the m...
Page 15: Different Kinds of Detergent
Detergent tablets detergent tablets from different manufactures dissolve at different rates. For this reason, some detergent tablets do not attain their full cleaning power during short washing programmes. Therefore please use long washing programmes when using detergent tablets, to ensure the compl...
Page 16: Washing Programmes
(1) testing programme for en 50242 (see "hints for test centres"). This programme, developed for the use of detergents with enzymes, allows you to achieve, with reduced consumption of energy the same cleaning results that would otherwise be obtained only with the 65°c programmes and conventional det...
Page 17: Starting A Washing Programme
In this fully integrated appliance the controls are located on the top of the door. When selecting a programme, the door needs to be open. 1. Check that the baskets have been loaded correctly and that the spray arms can rotate freely 2. Turn on the water tap 3. Press the on/off button the indicator ...
Page 18
"3 in 1" function this function can be selected together with all programmes. Place the 3 in 1 combi detergent tablet in the detergent dispenser. Press the "on/off" button. Press the 3 in 1 function button, the correspondent indicator light illuminates. Remember that if this function is selected, it...
Page 19: Maintenance and Cleaning
Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc....). Ensure that the seals around the door, the detergent and rinse aid dispensers are...
Page 20: What to Do, When...
Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions given here, without calling out an engineer. What to do, when... 41 ...A flashing fault code appears the dishwasher will not start or stops during operation. The interventi...
Page 21
...The wash results are not satisfactory the dishes are not clean ● the wrong washing programme has been selected. ● the dishes were arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded. ● the spray arms do not rotate freely due to wrong arran...
Page 22: Hints For Test Centres
Testing in accordance with en 60704 must be carried out with appliance fully loaded and using the test programme (see "washing programmes" chart). Test in accordance with en 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectivel...
Page 23
Änderungen vorbehalten subject to change without notice 152960 81/2 11/05 boretti b.V. De dollard 17 - 1454 at - watergang. Www.Boretti.Nl belangrijke telefoonnummers: storingen 0900-2352673 onderdelen 0900-7727372 overige vragen 020-4363439.