Premier bombardier passenger set operator’s manual compatibility the premier bombardier cars easily increase seating capacity on your hard working passenger lines. The control unit, found in the 4-car sets, with its additional lights and cab, gives the illusion that it's taking charge when you back ...
Table of contents operating control car lights...................................................................................3 changing coach car lights......................................................................................4 changing control car lights................................
Control car lights are operated by a switch inside the car. Switch: controls headlights and marker lights. Position 1 (position closest to you) = marker lights on. Headlight and ditch-lights off. Position 2 (center position) = marker lights off. Headlight and ditch-lights on. Position 3 (position fa...
Changing the roof lights- coach car to access roof lights: 1. Remove the 10 recessed screws. 2. Carefully lift body upward. You will need to pull the body outward, over the door handrails. 3. Unplug wires from circuit board. Chassis mounting screws 4 the sides have to be pulled out and lifted over t...
Changing the roof lights- control car 1. Remove the 10 recessed screws. 2. Carefully lift body upward. You will need to pull the body outward, over the door handrails. 3. Unplug wires from circuit board. 4.To replace the roof bulbs, grasp the base (not the bulb itself) firmly with a pair of needleno...
1. Unscrew the 2 screws that hold the plastic light housing. 2. Pull the bulbs from the housing and remove the wires and 2-pin connector. Replace entire wire harness unit. If you had to pull any of the lighting wires from their track in order to change the bulbs, tuck them carefully back into place ...
4. To remove the end bulbs pull the holder out of the guide and remove the bulb. To access the interior lights 1. Follow steps 1-3 on page 4 for accessing roof lights, then: 2. Remove the 4 screws on the top level to release the first level light holder. 3. Pull the light holder out and replace the ...
Kadee coupler mounting 1. Remove 14 screws from the bottom of the car and remove the undercarriage from the body. 2. Remove 2 truck mounting screws. 3. Remove the pilot from the truck by removing the 2 screws on top of the truck. To install an o-scale kadee coupler, please follow the instructions be...
Bombardier passenger set 4. Attach the pilot to the bottom of the base. Then remove the coupler from the truck and reattach the truck to the base. 5.Line the spacer & kadee coupler up w/the holes in the undercarriage and screw them down. 6. Reassemble the undercarriage in reverse order. 9.
4-car bombardier passenger set 10 service & warranty information how to get service under the terms of the limited one-year warranty when you suspect an item is defective, please check the operator's manual for standard operation and trouble-shooting techniques that may correct the problem. Addition...
