Rks sd70ace diesel engine operator’s manual (horn & bell) compatibility this engine will operate on any traditional o-31 gauge track system, including m.T.H.’s realtrax® or scaletrax™ or traditional tubular track. It is also compatible with most standard ac transformers. (see page 11 for a complete ...
Caution: electrically operated product: warning: when using electrical products, basic safety precautions should be observed, including the following: read this manual thoroughly before using this device. L m.T.H. Recommends that all users and persons supervising use examine the hobby transformer an...
Rks sd70ace with horn & bell 3 set up checklist r lubricate the engine lubricating the engine lubricate all exposed moving parts before operating using a multi-purpose, plastic- compatible oil (available with m.T.H.'s maintenance kit (#30-50010) , sold separately) or a light household oil. Follow th...
Rks sd70ace with horn & bell 4 basic operation the throttle knob controls how fast your train will travel. Turn the throttle knob up 1/8 to 1/4-way, until the engine lights shine bright. Put the engine into motion by pressing the direction button on your transformer once. (hold it for approximately ...
Manual volume control to adjust the volume of all sounds made by this engine, turn the manual volume control (shown below) clockwise to increase the volume and counter-clockwise to decrease the volume. You must first remove the fan cover to access the manual volume control. Manual volume control man...
Maintenance lubricating and greasing instructions the engine should be well oiled and greased in order to run properly. Regularly lubricate all axles and pickup rollers to prevent squeaking. Use light household oil, such as that found in m.T.H.'s maintenance kit. Do not over oil. Use only a drop or ...
5. After repeating the procedure for the other motor, reassemble the chassis and body, being careful that the wire harnesses are not caught between the chassis and body, and reinstall the body mount screws. Lubricate the outside truck block idler and drive gears with grease. Use the diagram shown be...
Traction tire replacement instructions your locomotive is equipped with two neoprene rubber traction tires on each powered truck block. While these tires are extremely durable, you may need to replace them at some point. First, remove the truck sides from the truck block. To do this, turn your engin...
Locomotive head lamp replacement to replace a burned out head lamp on this locomotive, follow these instructions. Follow the cab removal instructions in the “lubrication and greasing instructions” section on pg. 6 of this manual. Once the body has been removed, locate the burned out lamp(s). Careful...
Troubleshooting although the horn and bell model has been designed and engineered for ease of use, you may have some questions during initial operation. The following table should answer most questions. If your problem cannot be resolved with this table, contact m.T.H. For assistance (order online: ...
Transformer compatibility and wiring chart the horn & bell model is designed to work with most standard ac transformers. The chart below lists the many compatible transformers. Note that many of the operational commands described in these instructions require a bell button, so if your transformer do...
Service & warranty information how to get service under the terms of the limited one-year warranty when you suspect an item is defective, please check the operator's manual for standard operation and trouble- shooting techniques that may correct the problem. Additional information may be found on th...
