M.T.H. 7020 columbia gateway drive columbia, md 21046-1532 www.Mth-railking.Com the railking operating car wash is sure to add fun and authenticity to any layout. With moving car and figures, digital conversations, and even a smoke unit to replicate the mist inside the car wash, this operating build...
2 the railking car wash is made up of three components: the car wash building and base, the car, and the activation button. Before you place the car wash on the layout, you must wire the car wash to the activation button and power source. In order to connect power to each component, the six (6) encl...
3 priming the smoke unit: it is essential that you either prime the smoke unit or turn the smoke unit off before you operate the car wash. Failure to do so could result in a charred wick and damaged mechanisms. 1. To prime the unit, remove the cap of the smoke stack on top of the car wash (fig. 2) a...
Operating instructions: before operating the car wash, you must first place the two drying figures and the car on the base. Insert the tabs on the bottoms of the drying figures into their slots in the following order: the man wearing the white shirt goes in the slot nearest the car wash exit, and th...
5 rinse and dry lights 1 1 1 rinse and dry lights: remove the clear shield over the rollers and gently pop the green and red rinse and dry sign off the base of the car wash. Pull the lights out and push the new ones in to replace them (like christmas tree lights). Changing the lights shield over rol...
6 garage door lights clear shield over rollers sign lights building lights 2 1 3 4 3 4 2 building light: twist the light bulb counterclockwise to remove it. Push the replacement bulb in and twist it clockwise. To access and change the other lights: remove the clear shield over the rollers. Remove th...
7 1 2 3 4 5 disconnect the tube that connects the smoke unit to the pipe in the bay door remove the five mounting screws that hold the smoke unit to the under side of the roof of the car wash housing remove the four screws from the top of the smoke unit to reveal the wick inspect the wick , if the w...
8 1 2 3 4 5 6 7 8 9 1 0 1 3 16 1 1 14 17 1 2 15 1 8 19 20 pcb board diagram 1. Interior light (de) 2. Sign light (adl) 3. Cashier light to pcb (cl) 4. Door motor to pcb (dm) 5. Car motor to pcb (cm) 6. Door opening micro switch to pcb (do) 7. 8. Rinse light (rinse) 9. Warming light (warn) 10. Garage...
9 notes:______________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ _____________________________________...
10 notes:______________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ____________________________________...
11 notes:______________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ____________________________________...
How to get service under the terms of the limited one-year warranty for warranty repair, do not return your product to the place of purchase. Instead, follow the instructions below to obtain warranty service, as our dealer network is not prepared to service the product under the terms of this warran...
