Summary of Legend I
Page 1
Iljjtech -.M-ta::hdy.-nlc..Cam @ :a (e:0890(d - legend i mobile cb radie owner's manual.
Page 2
Table of contents 1. Introduction ........................................................................ 1 2. Included in y our package············································· 1 3. Features ··················································································· 1 4. Controls and r...
Page 3
1. Introduction this specification is the operating guide for the software of cb transceiver legend i. 2. Included in your package it any of these items are missing or damaged, immediately confact your place of purchase. Legend i cb rodio microphone and hook. Mounting braclc.Et, knobs, and mounting ...
Page 4
4. Controls and rear panel • these drawings ore just for reference, and do not reflect the final product. 9 3 2 figure 4-1-1. Controls 3 figure 4-1-2. Microphone p.2 7.
Page 5
4.1 controls table 4-1-1. Key i knob i other function i microphone switch function function a} push switches 1st function 2nd function (press this $witch momentanly) (press this switch for one second) 1 2 3 [f) [up] ([&]) [dn] (iy]l b} slfde switch 4 [am/fm] ([cept i eng]) - c) knob and other 5 [vol...
Page 6: Txamfm
5. Display 5.1 lcd display and other display txamfm ill figure 5-1-1. Lcd display table 5-1. Lcd display element of lcd contents of the indicator lhe configuration code is displayed at power on. Lhe configuration code is displayed at configurafion ldl-. 2-digits select mode. !Only multi configur...
Page 7
6. Tones table 6-1. Beep tone description tone contents of the indicator key touch tone • when the push switch is pressed and the each (single tone) setting is switched to other than off. • when priority ch9 or 19 modes is on by [9/19] switch. • [up] switch is pressed (except for auto repeat functio...
Page 8
?. Installation connect the microphone align the microphone connector with the jack on the front of the radio. Push the connector in firmly and secure it with the locking screw. Connect the power you can connect the radio to any standard 12 volt dc power source, with a negative ground. If you don't ...
Page 9
8. Operations 8.1 common items 1. Only for multi configuration mode, when power on is done while [fl switch is not pressing, then it becomes normal state of the receiving and transmitting. When power on is done while [fl switch is pressing, then it becomes configuration select mode. At this state, i...
Page 10
• when power on is done when (pti] switch is being pressed, then transmit is not possible, and "tx" icon and the channel indicator blink: as long as [ptt] switch is pressed. • the example of the display, when power on is done is shown. -> after 2 seconds -> (configuration code) (channel number) 8.3 ...
Page 11
- it is adjusted to rf gain up when this knob is turned to the clockwlse direction. • normally, this knob is on maximum (fully clockwise). 8.8 cb channel select - push the [up] switch to move up the channel list. - push the [dn] switch to move down the channel list. 8.9 am/fm mode [except for ec, uk...
Page 12
- press and hold the (pti] swhch. "tx" icon tums on. - hold the microphone about 2 lnches away from your mouth and speak in a normal voice. - release the swffch to lls1en for a r esponse. •tx" icon turns off. * when power on is done when [pti] switch is being pressed, then transmit is not possible. ...
Page 13
L (eu) - 2(pl) - 3(dj - 4(ec) - 5(u) - t ! 4. Similarly. When the [on] switch is pressed. Configuration code is changed as follows. 1 (eu) +- 2(plj +- 3(dj +- 4(ec) +- s(u) + ! T 5. When you choose configuration that wants to be used, press the [f] switch for one second. - the new configuration is ...
Page 14
• while configuration select mode, channel number cannot be changed by using [up]/[dn] switch. • in each configuration, channel number is separately memorized. • only when "f" icon and channel indicator ore blinking while configuration select mode, configuration can be changed by using [up]/[dn] swi...
Page 15
8.16 key lock function on/off key lock function is a function to disable [up]/[dn] switch, [9/19] switch and band select operation. Push [lock] switch on the microphone for one second to switch the key lock func tion on/off. Key lock function off+----+ key lock function on * [ptt] switch is accepte...
Page 16
9. Maintenance every six to twelve months, check to make sure that... the voltage standing wave ratio (vswr} is less than 2:1. all electrical connections are secure and free of corrosion. the antenna cable shows no wear or damage. all mounting screws are securely fastened. 10. Troubleshootin...
Page 17
11. Specifications general channels 40 am/fm (config. Eu) frequency range 26.965 to 27.405 mhz (config. Eu] frequency control phase locked loop (pll] synthesizer frequency tolerance ±600hz operating temperature -10 ° c to +55 ° c microphone electret condenser type microphone input voltage 12.0v dc c...
Page 18
12. Frequency list 12.1.L configl frequency list (eu configuration) configl europe 40ch fm (4w), 40ch am [4w) ch frequency (mhz) amrx amtx fmrx fmtx no. L 26.965 0 04w 0 04w 2 26.975 0 04w 0 04w 3 26.985 0 04w 0 04w 4 27.005 0 04w 0 04w 5 27.015 0 04w 0 04w 6 27.025 0 04w 0 04w 7 27.035 0 04w 0 04w ...
Page 19
12.1.2 config2 frequency list (pl configuration} config2 poland -5khz 40ch fm (4wj , 40ch am (4wj ch frequency (mhz) amrx amtx fmrx fmtx no. 1 26.960 0 04w 0 04w 2 26.970 0 04w 0 04w 3 26.980 0 04w 0 04w 4 27.000 0 04w 0 04w 5 27.010 0 04w 0 04w 6 27.020 0 04w 0 04w 7 27.030 0 04w 0 04w 8 27.050 0 0...
Page 20
12.1.3 config3 frequency list (d configuration) config3 germany boch fm (4w). 40ch am [4w) ch frequency amrx amtx fmrx fmtx ch frequency amrx amtx fmrx fmtx no. (mhz) no. (mhz) 1 26.965 0 04w 0 04w 41 26.565 x x 0 04w 2 26.975 0 04w 0 04w 42 26.575 x x 0 04w 3 26.985 0 04w 0 04w 43 26.585 x x 0 04w ...
Page 21
12.1.4 config4 frequency list (ec configuration} config4 cept 40ch fm (4w) chno. Frequency (mhz) amrx amtx fmrx fmtx 1 26.965 x x 0 04w 2 26.975 x x 0 04w 3 26.985 x x 0 04w 4 27.005 x x 0 04w 5 27.015 x x 0 04w 6 27.025 x x 0 04w 7 27.035 x x 0 04w 8 27.055 x x 0 04w ' 27.065 x x 0 04w 10 27.075 x ...
Page 22
12.1.5 config5 frequency list (uk configuration) config5 cept 40ch fm (4w) , eng 40ch fm (4w) cept frequency mode england frequency mode ch frequency am amtx fm rx fmtx ch frequency amrx amtx fm fmtx no. [mhz] rx no. [mhz] rx 1 26.965 x x 0 04w 1 27.60125 x x 0 04w 2 26.975 x x 0 04w 2 27.61125 x x ...
Page 23
P.21 13. Certificate of conformity.
Page 24
Printed in china uol ut387 azb(o) www.M-techdynamic.Com this user manual is subject to change according to m-tech dynamic corporation limited without notice..