M2 Antenna Systems 17M5DX Assembly Manual

Summary of 17M5DX

  • Page 1

    M2 antenna systems, inc. 4402 n. Selland ave. Fresno, ca 93722 tel: (559) 432-8873 fax: (559) 432-3059 web: www.M2inc.Com ©2014 m2 antenna systems incorporated 08/9/12 rev.02 model ........................................ 17m5dx frequency range ...................... 18.080 to 18.18 mhz *gain, (fs) ...

  • Page 2: 17M5Dx Assembly Manual

    Note: a small cup of zinc paste (penetrox, noalox, or equivalent) has been provided to enhance the quality of all the electrical joints in this antenna. Apply a thin coat wherever two pieces of aluminum come in contact. 1. Boom layout begin with laying out all five of the boom sections as they would...

  • Page 3: 17M5Dx Assembly Manual

    7. Now adjust the element spacings exactly, following the 17m5 dimension sheet. Since the reflector element is fixed at 1”, use it as the primary measurement reference. Dimensions given are “center to center” but can also be used "edge to edge" with a tape measure. Position the driven element as sho...

  • Page 4: 17M5Dx Assembly Manual

    11. General mounting considerations this completes the assembly. When the antenna is installed in position on the mast, the main feed line can be attached and sealed at that time. Remember to support the feed line at the antenna boom and on the mast. Leave an adequate feed line loop for rotation aro...

  • Page 5: 17M5Dx Dimension Sheet

    17m5dx dimension sheet 432.

  • Page 6: 17M5Dx Parts & Hardware

    Description .................................................................... Qty boom section, 2" x .058 x 72” ........................................................ 1 boom section, 2” x .058 x 91” ........................................................ 1 boom section, 2-1/2” x .065 x 95” swa...